CASIO Module No.

Module Numbers

The following module numbers are covered in this manual:

705, 706, 707, 708, 709, 1300, 1309, 1311, 1330, 1331, 1332, 1333, 1334, 1335, 1336, 1342, 1344, 1345, 1346, 1347, 1360, 1362, 1369, 1370, 1373, 1398, 1399, 1701, 1710, 1711, 1747, 1770, 1771, 1782, 1787, 2717, 2718, 2719, 2725, 2731, 2748, 2749, 2783, 2784, 2799, 3363, 3378, 3711, 3712, 3716, 4328, 4370, 4393, 4394, 4747, 5025, 5044, 5049, 5058, 5116, 5125, 5128, 5167, 5180, 5199, 5206, 5207, 5218, 5223, 5237, 5249, 5250, 5284, 5339, 5340, 5341, 5342, 5343, 5352, 5358, 5361, 5364, 5373, 5375, 5383, 5393, 5436, 5458, 5474, 5507, 5532

Water Resistance

Important Information: Read Before Use

For all categories of watches, the following actions are prohibited while underwater:

• Pressing buttons
• Changing the time (moving hands)
• Unscrewing the crown

If the watch is exposed to saltwater, rinse it thoroughly and dry it. Do not wear a watch with a leather strap while swimming. Avoid prolonged contact of leather straps with water.

Watches are classified by water resistance ratings (from I to V) based on their degree of protection against water. Consult the table below to determine the correct usage for your watch.

Water Resistance Ratings Table

Notes:

• I: Watches are not protected against water. Avoid exposure to any moisture.
• II: WR (Water Resistant) means the model is waterproof according to ISO 2281. Brief contact with water will not cause problems.
• III: Watches with 5 Bar (50 meters) water resistance can withstand water pressure as indicated and can be used during showers and brief swimming.
• IV: Water resistance of 10 Bar (100 meters) means the watch can be used during normal swimming and snorkeling.
• V: Water resistance of 20 Bar (200 meters) means the watch can be used for scuba diving (excluding depths requiring a helium-oxygen mixture).

When using the product in conditions of rapid temperature changes, slight condensation may form on the inside of the glass. This phenomenon is due to the laws of physics and is not a defect.

CASIO COMPUTER CO., LTD. is not responsible for any damage that may occur during the use of this watch and does not accept any claims from third parties.

Screw-Lock Crown

Your watch may differ slightly from the illustrations in this manual.

Note: Some water-resistant models are equipped with a screw-lock crown.

• To pull out such a crown, you must first unlock it by turning it in the direction indicated in the diagram. Do not apply excessive force when pulling out the crown, as this may cause damage.
• Be aware that the watch loses its water resistance when the crown is pulled out. After completing any operations with the crown, return it to its original position and lock it.

Diagram Description: A watch face is shown. An arrow indicates turning the crown to unlock it. The crown is labeled "Заводная головка" (Crown). Another diagram shows the crown in a pulled-out position.

Setting Current Time

Instructions vary by module number.

Modules 1362, 1398, 1770, 2799, 3378, 4370

Setting the Current Time

Pull out the crown. Turn it to set the hands to the current time. Push the crown back to its original position.

Diagram Description: A watch face is shown with hands. The crown is labeled "Заводная головка" (Crown).

Modules 705, 706, 1300, 1311, 1330, 1344, 1360, 1399, 1747, 1771, 1782, 4328, 4394, 4747, 5049, 5284, 5361, 5364, 5375, 5577

Setting the Current Time

1. When the second hand is at the 12 o'clock position, pull out the crown. The second hand will stop.
2. Turn the crown to set the hands to the current time. Set the minute hand 4-5 minutes ahead of the current time, then move it back.
3. Close and secure the crown upon hearing the time signal.

Diagram Description: Two watch faces are shown. The first shows the second hand at 12 o'clock. The second shows the crown pulled out. A separate diagram shows a watch face with the crown and arrows indicating crown positions for date and time setting. It also lists module numbers 5284, 5361, 5364, 5375, 5577.

Modules 707, 708, 1331, 1332, 1335, 1336, 1342, 1345, 1346, 1369, 1370, 1373, 1701, 1710, 1711, 1787, 2717, 2718, 2719, 2725, 2731, 2748, 2749, 2783, 2784, 3363, 3711, 3712, 4393, 5025, 5044, 5058, 5116, 5128, 5180, 5199, 5206, 5207, 5218, 5250, 5340, 5341, 5342, 5343, 5352, 5358, 5383, 5393, 5436, 5507, 5532

Setting the Current Time

1. When the second hand is at the 12 o'clock position, pull out the crown. The second hand will stop.
2. Turn the crown to set the hands to the current time. To fine-tune the current time, move the minute hand 4-5 minutes back from the desired value, then return it to the current value.
3. Push the crown back to its original position to resume time display.

Diagram Description: A watch face is shown with the crown. Arrows indicate the crown's normal position, first click (date setting), and second click (time setting). The date display shows "30".

Modules 709, 1309, 1333, 1334, 1347, 3716, 5125, 5167, 5223, 5237, 5249, 5339, 5373, 5458, 5474

Setting the Current Time

1. When the second hand is at the 12 o'clock position, pull out the crown. The second hand will stop.
2. Turn the crown to set the hands to the current time. To fine-tune the current time, move the minute hand 4-5 minutes back from the desired value, then return it to the current value.
3. Push the crown back to its original position to resume time display.

Diagram Description: Two watch faces are shown with crowns. The first indicates "Первый щелчок установка даты и дня недели" (First click date and day of week setting) and "Второй щелчок установка времени" (Second click time setting). The second diagram is similar. Module numbers 709, 1333, 1347, 3716 are associated with one diagram style.

Setting Date and Day of Week

Important: To ensure the date and day of the week change at midnight, do not perform date settings between 8:00 PM (20:00) and 2:00 AM.

1. Pull out the crown to the first click.
2. Turn the crown to set the desired date.
3. Turn the crown to set the desired day of the week. Days of the week are indicated in English or Spanish.

Table:

4. Push the crown back to its original position.

Watches with Backlight

Press and hold the L button to illuminate the watch face.

• Depending on the watch model, the backlight duration is 2 to 3 seconds, or 1 second, or stays on while the L button is pressed (Module 5577).
• Depending on the watch model, the backlight is provided by electroluminescent (EL) elements or LEDs. EL elements lose power after prolonged use.
• Frequent use of the backlight reduces battery life.
• Activating the backlight for an extended period or when the battery charge is low may cause the watch hands to stop moving for a while.

Diagram Description: Two watch faces are shown, indicating the position of the "L (Кнопка подсветки)" (L Button) and "Заводная головка" (Crown).

Watches with Rotating Bezel (Unidirectional)

Turn the bezel to align the marker with the minute hand. After some time, you can tell how much time has passed since you aligned the marker with the minute hand.

Diagram Description: A watch face is shown with a rotating bezel. The bezel has markings for minutes (10, 20, 30, 40, 50, 0). The bezel is labeled "Безель для измерения прошедшего времени" (Bezel for measuring elapsed time).

Technical Specifications

Technical specifications are subject to change without prior notice.

Product Information

Product Name: Electronic / Electro-mechanical quartz wristwatches (men's/women's)

Brand: CASIO

Manufacturer: CASIO COMPUTER Co.,Ltd.

Manufacturer Address: 1-6-2, Hon-machi 1-chome, Shibuya-ku, Tokyo 151-8543, Japan

Importer: OOO "Kasio", 127015, Russia, Moscow, Butyrskaya str., bld. 77

Warranty Period: 2 years

Address for Authorized Organization for Claims: Specified in the warranty card