Important Information
As wall materials vary, screws for fixing to wall are not included. For advice on suitable screw systems, contact your local specialised dealer.
? Ensure you use appropriate fixings for your wall type. If unsure, seek professional advice.
Assembly
Step 1
Attach two mounting brackets (part number 10081537) to the roller blind mechanism. Position these brackets 10 cm (3 15/16") from each end of the mechanism.
Visual Description: Two brackets (10081537) are attached to the roller blind mechanism, spaced 10 cm from each side.
Step 2
Mount the roller blind assembly onto the wall or ceiling brackets. Ensure it clicks securely into place.
Visual Description: The roller blind assembly is shown being attached to pre-mounted wall brackets.
Step 3
Securely attach the mounting brackets (part number 10081537) to the roller blind mechanism.
Visual Description: Close-up views show the detailed attachment of brackets (10081537) to the roller blind mechanism.
Step 4
Fix the mounting brackets to the wall or ceiling using appropriate screws (not included). Ensure they are level and securely fastened.
Visual Description: Diagrams show brackets being screwed into a wall or ceiling. The text "2x" indicates two brackets are used.
Step 5
Slide the roller blind mechanism onto the wall-mounted brackets. Ensure it locks into place. The pull loop (part number 10046985) is attached to the bottom bar.
Visual Description: The roller blind mechanism is shown being slid onto the wall brackets. A close-up shows the pull loop (10046985) on the bottom bar.
Step 6
Unfold the decorative front cover.
Visual Description: A hand is shown unfolding the long, flat decorative front cover.
Step 7
Slide the decorative front cover onto the roller blind mechanism until it clicks into place.
Visual Description: The front cover is slid onto the roller blind assembly, with arrows indicating movement, and a "Click!" label signifies secure attachment.
Operation
Lowering: Gently pull the cord. The blind will descend and hold its position. The diagram shows a "STOP" indicator.
Raising: Pull the cord upwards. The blind will roll up. The RIKTIG pull stick can be used for easier operation.
Visual Description: Diagrams illustrate pulling the cord to lower and raise the blind. A diagram shows the RIKTIG pull stick.
