Free Standing Wardrobe

Panels

• Left Side Panel: 1 PC
• Right Side Panel: 1 PC
• Divider: 1 PC
• Back Panel: 2 PCS
• Bottom Panel: 1 PC (Note: Has 3 x Dowels)
• Top Panel: 1 PC (Note: Has 2 x Dowels)
• Adjustable Shelf
• Kick Board: 2 PCS

Parts

• Camlock and Pin
• 32mm Screw
• Rail Holder
• Shelf Cam and Pin: (x4 per shelf)
• Screw: (For Rail Holder / L Bracket / Top Track)
• Hanging Rail

Assembly Steps

Step 1: Fit Plinths to Bottom Panel

Fit the plinths to the bottom panel, ensuring they are offset by 1mm from the edge. The bottom panel has 3 dowels.

Diagram Description: Shows the bottom panel with two plinths attached using screws. An inset highlights the 1mm offset from the panel edge.

Step 2: Attach Back Supports to Mid Panel

Attach two back supports to the mid panel using connectors.

Diagram Description: Depicts a mid panel standing vertically, with two back support pieces attached to its rear surface using circular connectors.

Step 3: Attach Mid Panel Assembly to Bottom Panel

Fit the mid panel assembly (with back supports attached) onto the bottom panel.

Diagram Description: Illustrates the bottom panel lying flat, with the mid panel and its attached back supports erected vertically and connected to the bottom panel.

Step 4: Fit Back Panels and Base Support

Fit the back panels and the back support to the base structure.

Diagram Description: Shows the partially assembled wardrobe frame. Two back panels are being fitted to the rear, and the back support continues down to the base.

Step 5: Fit Top Panel

Fit the top panel onto the assembled structure. The top panel has 2 dowels.

Diagram Description: Illustrates the top panel being placed and secured onto the upright structure, completing the main box frame.

Step 6: Fit Side Panels

Fit the left side panel (L) and the right side panel (R) to the main structure. Connectors are used to join the panels.

Diagram Description: Shows the wardrobe frame with the left and right side panels being attached to the edges of the top, bottom, and mid panels.

Step 7: Fit Hanging Rail

Install the hanging rail. This involves fitting hanging brackets to the side panels and then placing the hanging rail onto the brackets.

Diagram Description: Depicts the interior of the wardrobe. Hanging brackets are shown attached to the inner sides of the side panels, with a hanging rail positioned to rest on these brackets.

Step 8: Fit Tracks

Fit the top track flush with the front edge of the top panel using the provided screws. Fit the bottom track 5mm back from the front edge of the bottom panel using the provided tape.

Diagram Description: Shows the top section of the wardrobe with the top track installed along the front edge of the top panel. The bottom section shows the bottom track installed 5mm back from the front edge of the bottom panel.

Step 9: Fit Sliding Doors

Fit the sliding doors. Adjust the bottom wheels using an allen key for proper alignment and smooth operation.

Diagram Description: Illustrates a sliding door being carefully inserted into the top and bottom tracks. Close-up insets show how to adjust the wheels at the bottom of the door using an allen key.

Step 10: Final Assembly

Complete the assembly by adding shelves and ensuring all components are secure. The wardrobe is now finished.

Diagram Description: Presents the fully assembled wardrobe with both sliding doors closed, revealing the interior with shelves and the hanging rail in place.