Installation Instructions
Sliding Doors
5 EASY STEPS
Step 1
[Description of image 1: A drill bit is shown pre-drilling holes into a metal track.]
Use a 5mm drill bit to pre-drill mounting holes for the top track where necessary.
Step 2
[Description of image 2: A hand holds a screwdriver, tightening a screw into a track.]
Peel Plastic off top and bottom tracks. Align the top track flush with the front of your door jamb, Screw the top channel to header, ceiling or door jamb with screws provided.
Step 3
[Description of image 3: Double-sided tape is being applied to a metal track. Another view shows the track positioned 5mm from a surface, indicating placement.]
Position the bottom track ensuring it is placed 5mm in from the front of the wardrobe before securing. If a packer has been provided, this needs to be screwed/glued to the hard surface under the bottom track first. when ready to secure, peel off the backing of the double-sided tape and mount in place.
Step 4
[Description of image 4: A person is holding a sliding door, guiding its top edge into a channel.]
Slip the top of door into rear channel then set bottom onto the rear floor track by pushing up the bottom wheels to help slot in place. Repeat for second door using the front channel.
Step 5
[Description of image 5: A hand uses an allen key to adjust a wheel mechanism on a sliding door track. An oval highlights the adjustment hole.]
Pull up the bump stop enough to reveal the adjusting hole. Use a 4mm allen key to adjust wheels. (Clockwise to raise or Anti-clockwise to lower). This adjustment helps ensure the doors align properly with the door jambs.
