Stroller Wagon Infant Car Seat Adapter

Important Safety Instructions

⚠️ WARNING: To ensure safe operation of your product, please follow these instructions carefully. Please keep these instructions for future reference.

IMPORTANT: Before assembly and each use, inspect this product for damaged hardware, loose joints, missing parts or sharp edges. NEVER use if any parts are missing or broken.

IMPORTANT: Adult assembly is required. Keep child away during unpacking and assembly.

Warranty

The Baby Trend® warranty covers workmanship defects within 1 year of purchase. Any product subjected to misuse, abuse, abnormal use, excessive wear and tear, improper assembly, negligence, environmental exposure, alteration, or accident, or with an altered/removed serial number, invalidates all claims against the manufacturer. Any damage to property during installation is the sole responsibility of the end user.

Customer Service Department can be contacted at 1 (800) 328-7363 Monday through Friday between 8:00 a.m. and 4:30 p.m. (PST). Return Authorizations are required prior to returning product(s) to Baby Trend®. Please visit http://babytrend.com/pages/limited-warranty for complete warranty details.

Compatibility

This adapter type is only compatible with Stroller Wagons (WG01, WG03).

For wagon, car seat instruction manual and compatibility chart, visit babytrend.com.

• Only compatible with models sold in the U.S.
• Compatibility is subject to revision over time.

Assembly Instructions

Attaching the Adapter

1. Unfold the adapter and place it on a flat surface [diagram: adapter unfolded on flat surface].
2. Connect both ends of the adapter bars together as shown [diagram: adapter bars connected].
3. Ensure both pins click into the holes. Flip the adapter [diagram: adapter flipped].
4. Always remove the child tray and canopy from the wagon to install the adapter. Refer to WG01 and WG03 manuals for removal instructions of the child tray and canopy.
5. Open the clips on both sides of the adapter, open the flaps on the wagon cover to expose the bar connection [diagram: clips and flaps opened].
6. Face the front of the adapter to the front of the wagon. Align the clips to the bar as you press them into place [diagram: aligning clips to bar].
7. Close the clips firmly from the inside with your thumbs and check that it is secured into the frame [diagram: closing clips from inside].

Removing the Adapter

1. To remove the adapter, wrap your thumbs over the wagon frame and use all your other fingers to apply pressure on the clip to release it from the bar [diagram: removing adapter clip].
2. NOTE: Refer to pages 7 and 8 for car seat installation.

Car Seat Installation

INFANT CAR SEAT Sold separately.

1. Place the car seat onto the Car Seat Adapter. The front of the car seat should be facing the same direction as the stroller wagon handle. Ensure the car seat stoppers are resting on the Adapter Bars [diagram: car seat placed on adapter, showing stoppers].
2. Strap the Safety Belts through the Belt Path on the Car Seat and connect the buckles together [diagram: safety belts threaded through path and buckled].
3. Tighten the strap so it fits snugly and the car seat is secured to the frame [diagram: tightened strap securing car seat].
4. NOTE: The Safety Belt MUST ALWAYS be installed through the Belt Path before using this product.
5. REMOVAL: Release the safety strap [diagram: releasing safety strap], reverse step 3 and then follow step 2.

Important Safety Information for Car Seat

⚠️ Always ensure infant car seat is properly positioned, secured with the safety strap with the seat back NOT positioned too upright. The child's head should sit back against the seat. If the seat back is positioned too upright, a newborn to six months old child's head could fall forward.