Endgame Gear OP1we Kailh GO Switch Pack Installation
Introduction
This guide provides step-by-step instructions for installing the Kailh GO Switch Pack for your Endgame Gear OP1we mouse. Please follow these instructions carefully to ensure proper installation.
Tools Required
You will need a small Phillips head screwdriver to complete the installation.
Installation Steps
-
Step 1: Disconnect and Prepare
Ensure the mouse is disconnected from your computer. Turn the mouse over to access the bottom. Locate the power switch and ensure it is in the 'off' position. The image shows the bottom of the mouse with the power switch clearly marked as 'off' and 'on'. An arrow indicates the direction to move the switch to the 'off' position.
-
Step 2: Unscrew the Bottom Shell
Using a Phillips head screwdriver, remove the two screws securing the bottom shell of the mouse. The image shows two screws being removed from the bottom of the mouse, with arrows pointing to their locations. The bottom shell is shown partially detached.
-
Step 3: Detach the Top Shell
Carefully lift the top shell of the mouse away from the bottom shell. Disconnect the ribbon cables connecting the top shell components to the main board. The image illustrates the top shell being lifted, revealing internal components and ribbon cable connectors that need to be unplugged.
-
Step 4: Remove Existing Switches
Locate the existing mouse switches. Carefully disconnect their ribbon cables from the main board. The image shows four ribbon cables connected to the main board, with arrows indicating they should be disconnected.
-
Step 5: Install the Kailh GO Switch Pack
Connect the ribbon cables of the new Kailh GO Switch Pack to the corresponding ports on the main board. Ensure the connectors are securely seated. The image shows the Kailh GO Switch Pack with its ribbon cables being connected to the mouse's main board.
-
Step 6: Reassemble the Mouse
Carefully align the top shell with the bottom shell and reconnect any internal cables if necessary. Secure the top shell by reinserting and tightening the two screws removed in Step 2. Ensure the mouse is properly closed.
-
Step 7: Power On and Test
Turn the mouse over and switch the power button to the 'on' position. Connect the mouse to your computer and test all buttons to ensure they are functioning correctly.
Important Notes
Handle internal components with care to avoid damage. If you encounter any issues, refer back to these instructions or contact Endgame Gear support.
