Patura Calf Box Cover with Heating Plate

General Information

Assembly Time: Approximately 20 minutes.

Assembly requires: 2 persons.

Tools Required:

• Wrench set
• Socket wrench set
• 7 mm drill bit
• Hex wrench set
• Drilling machine

Included in Delivery

Installation Steps

Step 1: Attach Heater to Holding Frame

Secure the heater (1) to the holding frame (3) using the four M6 x 40 screws. The openings on the heater plate may need to be slightly bent to allow insertion of the screws.

Step 1A: Insert a screw through the U-profile of the holding frame (3) and fasten it with a non-self-locking nut.

Step 1B: Screw a non-self-locking nut halfway onto the screw thread. Slide two washers onto the screw, then screw on a self-locking nut until it is sufficiently tight.

Step 1C: Thread the screws into the heater plate (1) openings. Ensure one washer is placed below and one above each opening. Tighten all nuts securely.

Step 2: Attach Protection Basket

Screw the protection basket (2) to the four welded brackets on the holding frame (3). Use a hex wrench to tighten the M6 x 16 screws (8x).

Step 3: Mount Heater Assembly

The heater assembly, including the protection basket, can now be hung onto the side walls of the calf box using the two holding frames (3).

Step 4: Prepare Plastic Panel

On the short side of the plastic panel (4), drill two holes per U-profile (5). Position these holes 30 mm from the edge and 70 mm apart. The U-profiles (5) should be positioned approximately one-quarter of the way along the side length.

Diagram description: Illustrates drilling two holes on the short edge of a plastic panel. Key dimensions are shown: 125 mm total length, 70 mm distance between holes, 30 mm distance from the edge.

Step 5: Attach U-profiles to Plastic Panel

Using the supplied M6 x 35 countersunk screws (8x), attach the U-profiles (5) to the plastic panel (4).

Step 6: Final Assembly

The plastic panel with the mounted U-profiles can now be placed over the heater and attached to the side walls of the calf box.

Operation and Safety Instructions

The system is now ready for use. Before operating, check all screws and the function of the heater.

• Regularly clean the heater surface with a dry cloth.
• Check the heater's function before each use.
• Do not use the heater without the protection basket.
• Regularly check bolts and nuts and retighten if necessary.
• If the heater is damaged, it must not be used.
• Do not touch or cover the heater during operation (neither front nor back).
• Route the cable so the calf cannot touch it.
• Keep the heater away from water.
• Switch off the device when not in use.

Symbol: Crossed-out waste bin icon indicating not suitable for household waste.

Electrical Specifications

• Voltage: 220-240 V
• Power: 300 W
• Frequency: 50 Hz
• Protection Class: IP 65
• Certifications: CE, RoHS, TÜV Süd, SAA

Contact Information

Manufacturer: PATURA KG, Germany

Address: Mainblick 1, 63925 Laudenbach

Telephone: +49 93 72 9474 - 0

Fax: +49 93 72 9474 - 29

Website: www.patura.com

Email: info@patura.com