Assembly Instructions - Model IN230800118V03_GL
This document provides step-by-step assembly instructions for the product identified by model number IN230800118V03_GL and part number 921-149. Please follow these instructions carefully to ensure correct assembly.
Important Warning
Do not confuse similar screws.
This warning is also applicable in French: Ne pas confondre des vis similaires. In Spanish: No confunda tornillos similares. In Portuguese: Não confundir parafusos semelhantes. In German: Verwechseln Sie ähnliche Schrauben nicht. In Italian: Non confondere le viti simili.
Hardware
| Label | Type | Quantity |
|---|---|---|
| L | M6*20MM | 4 |
| M | M6*25MM | 4 |
| N | M8*20MM | 3 |
| O | M8*40MM | 4 |
| H | MX4 (Type/Quantity) | 1 (Implied by Step 01) |
Components
| Label | Description |
|---|---|
| A | Component |
| B | Component |
| C | Component |
| D | Component |
| E | Component |
| F | Component |
| G | Component |
| I | Component |
| J | Component |
| K | Component |
| P | Component |
| Q | Component |
Assembly Steps
-
Step 01: Attach component F to component G. Use hardware H (MX4).
[Diagram Description: Shows component F being joined to component G, with component H indicated as the fastening method, labeled 'MX4'.]
-
Step 02: Connect component Q to component D. Components A, B, C, I, J, K, and M are also involved in this connection.
[Diagram Description: Illustrates component Q being attached to component D. Components A, B, C, I, J, K, and M are shown in proximity or as part of the connection.]
-
Step 03: Secure components N (x3) and Q.
[Diagram Description: Depicts components N (three units) and Q being fastened in place.]
-
Step 04: Attach component E using four units of component O.
[Diagram Description: Shows component E being connected using four units of component O.]
-
Step 05: Complete the assembly by connecting components E, O, P, and Q.
[Diagram Description: Illustrates the final assembly stage where components E, O, P, and Q are brought together and secured.]
