Pyramid Yamaha XSR900 Fly Screen Fitting Instructions

Fitting Steps:

• Attach the brackets to the fairing as shown in Figure 1.
• Attach the fly screen to the fairing using the M5 fittings as shown in Figure 2. Tighten the bolts until the rubber anchor nuts expand, holding the fly screen in place.
• Fit the fairing and fly screen assembly to the bike using the OEM bolts as shown in Figure 3. The brackets fit to the outside of the headlight brackets.
• The rubber trim provided can be fitted around the aperture of the fairing.
• Check fixings periodically.

Diagrams:

Figure 1: Bracket Attachment

Illustration showing the M5 Nyloc Nut, Bracket, M5 Washer, M5 x 16mm Bolt, Fairing, and M5 Rubber Anchor Nut for attaching the bracket to the fairing.

Figure 2: Fly Screen Attachment

Close-up images showing the M5 x 16mm Bolt + M5 Washer securing the fly screen, with a note indicating that bolt caps are provided to be fitted here. Another image shows the rubber trim fitted around the edge of the fly screen.

Figure 3: Bike Assembly

Illustration of the motorcycle's front end, highlighting the right-hand side bracket and left-hand side bracket being attached to the outside of the headlight brackets.

Contact Information:

For any questions, please contact Pyramid Plastics:

• Email: sales@pyramid-plastics.co.uk
• Phone: +44 (0)1427 677990
• Website: https://www.pyramid-plastics.co.uk/

Follow Pyramid Plastics on social media to stay updated and leave a review.