EXTOL CRAFT 3915 Hand Mitre Saw

Overview

The EXTOL CRAFT 3915 is a manual hand mitre saw designed for precise angled cuts in wood and various profiles. It is suitable for creating frames (quadrangle, pentagon, hexagon, octagon), letterboxes, small libraries, window and door frames, floor strips, and cutting aluminium, steel, and plastic profiles. The saw features a rigid cutting frame with an adjustable angle mechanism indicated by a metal scale, and is guided by four rigid riders for accuracy. The saw blade is 550 mm long. The maximum cutting height is 115 mm and the maximum cutting width is 110 mm.

Use

For work with wood, for quadrangle, pentagon, hexagon and octagon frames, letterboxes, small libraries, window and door frames, floor strips, aluminium, steel and plastic profiles. Cutting height is 115 mm and width is 110 mm.

Technical Details

Cutting Frame

Rigid frame with an adjustable cutting angle with a metal scale. It is possible to use a few basic limit stops to set the various angles.

Material of Base Board

Wood

Tensioning

It is recommended to use standard saw strip tension. The saw is supplied with a universal saw strip for wood and plastic, length: 550 mm. Replacement saw strips are available in two types: a) for wood and plastic, b) for light metals - Cu, Zn, Al, Ni.

Setting a Coarser Cut

It is possible to set a coarser cut using the rings (15).

Guiding the Saw

The saw is guided using four rigid riders, which ensures precision cuts.

Angle Adjustment

To cut the required angle, it is necessary to set the angle that expresses the remainder to 90°. For example, to cut an angle of 36°, it is necessary to set 54° on the scale (90° - 36° = 54°).

Assembly

1. Insert bolt (7) into the hole (17) in the guide frame (5), and then into hole (6) in the cutting table (1) and secure it in place using nut (8).
2. Screw the plastic indicator using bolt (18) on the guide frame (5) as shown in the figure.
3. Using four bolts (18), mount the table (1) on to the wooden base of the cutter (9).
4. Slide the plastic riders (14) together with the saw (20) on to the guide rods (12) and secure them in place using rings (15).
5. Screw the short clamping rods (11) with the clamping bolt (21) to the frontal part of the cutting table (1) and the long clamping rods (10) from the side.

Attention

⚠️ The saw strip heats up during the cutting process and may be hot. Danger of burns. Prior to replacing the saw strip, allow it to cool down.

Safety Instructions

Meaning of Markings on the Label

Read the user's manual before using the saw.

• ?️ During work with the saw, use certified eye protection with a sufficient level of protection.
• ? During work with the saw, use certified respiratory tract protection with a sufficient level of protection. Inhalation of dust is damaging to health.
• ? Use appropriate safety gloves when working with the saw.

Warranty Terms and Conditions

This product is covered for a warranty period (responsibility for defects) as set by law. If requested by the buyer, the seller is obliged to inform him about his rights relating to faulty performance (warranty terms and conditions) in written form. The warranty does not cover wear and tear or damage to the saw strip resulting from standard or incorrect use since this is not a manufacturing defect.

Contact Details

Manufacturer: Madal Bal a. s.

Address: Průmyslová zóna Příluky 244, 76001 Zlín, Czech Republic.

Website: extol.eu