MitoPRO+ / MitoPRO X Floor Stand Assembly and Wall Mount Guide

Step 1: Unbox and Contents

Unpack your floor stand. You will find:

• 1 stand
• 4 wheel castors
• 2 panel locking screws

Step 2: Attach Wheel Castors

Thread the provided castors into the base of the floor stand and hand tighten. Wheels are optional; skip this step if you prefer not to use them.

Step 3: Position the Stand

Flip the stand onto its castors and flip up the two side braces.

Step 4: Secure Braces

Add the two panel locking screws to secure the side braces.

Step 1: Prepare the Panel

Remove the lower two rubber feet from the back of your light panel using a small Philips head screwdriver before installation into the floor stand.

Step 2: Insert Panel into Stand

Insert your light panel into the floor stand and ensure it is seated properly.

Important Note: Ensure the panel is fully seated into the bottom of the stand by pushing downwards on the top of the panel.

Step 3: Secure the Panel

Use the two panel locking screws to secure the panel into place.

Step 4: Connect Power

Add the power cord to the panel. Refer to the panel user manual for instructions on how to operate your panel.

Step 1: Attach Wall Bracket to Panel

Attach the wall bracket to the back of the light panel using the provided screws.

Step 2: Prepare Wall Mounting Points

Mark the desired location on the wall. Install the wall anchors and screws at the marked points.

Step 3: Secure Panel to Bracket

Secure the panel to the bracket using the two panel locking screws.

Step 4: Mount Panel Assembly to Wall

Mount the panel assembly to the wall by attaching the bracket to the wall screws.