Eurotech Lighting YYR & YYS CCT Button Installation Guide

Product Overview

This document provides installation instructions and safety information for the Eurotech Lighting YYR and YYS CCT Button LED ceiling lights. For detailed specifications, please visit the Eurotech Lighting website: eurotechlighting.co.nz.

Product Specifications

Product Visuals

YYR Series Product Visual: A round, white LED ceiling light with a diffused cover, designed for flush mounting.

YYS Series Product Visual: A square, white LED ceiling light with a diffused cover, designed for flush mounting.

Installation Instructions

All installations must be carried out by a qualified electrician following local regulations. Ensure the power is switched off before installation. Read and follow the 'Installation instructions' and 'Safety instructions' sections carefully before commencing installation. Installation details may change; always read instructions before each installation.

1. Fix mounting bracket:
   • For power entry from the ceiling, position the bracket's center approximately 50mm up and 20mm across from the power cable.
   • For side power entry, ensure the bracket is parallel to the cable's angle.
   Insert two white expansion tubes through the mounting holes. Secure the bracket using 15mm screws for timber or 30mm screws for concrete surfaces.
2. Prepare fitting for mounting:
   • Attach the black EVA anti-vibration pads to the back surface of the lamp.
   • Set the desired color temperature using the switch on the side of the fitting.
3. Wire the fitting:
   • Open the connector block cover by squeezing the two clips and flipping the cover up.
   • Peel back approximately 20mm of the cable's plastic insulation. Connect the power to the Live and Neutral terminals on the fast push connector.
   • Once the wires are secure, press the waterproof cover down firmly to create a tight seal.
4. Fix the fitting to the ceiling: After completing the wiring, place any excess wire into the groove. Align the bracket with the mounting point on the back of the fitting and push to secure it in place. [Click sound indicates secure attachment]

Safety Instructions

Read these instructions carefully before commencing installation.

1. The light source in this luminaire should only be replaced by the manufacturer, their service agent, or a similarly qualified person.
2. This LED luminaire must be installed ONLY by a licensed electrician, adhering to all local regulations.
3. Ensure cables are not squeezed or damaged by sharp edges.
4. Clean the light with a soft cloth and a standard pH-neutral detergent.
5. Misuse of or alterations to the appliance will void all warranties.
6. Do not install on a surface that is unsuitable or deformed.
7. Do not install on or above a surface with high temperatures.
8. Avoid installing in environments with corrosive or explosive materials.