Vortex PG65 Quick Start Guide

Getting Started

1. Step 1: Eject SIM Card Tray

   Use the provided ejector tool to gently push into the small hole next to the SIM card tray on the side of the phone. The tray will pop out.

2. Step 2: Insert SIM Card

   Place your SIM card into the designated slot on the SIM card tray, ensuring it is correctly oriented.

3. Step 3: Insert Micro SD Card

   If you are using a Micro SD card, place it into the second slot on the SIM card tray, ensuring correct orientation.

4. Step 4: Reinsert SIM Card Tray

   Carefully slide the SIM card tray back into the phone until it is flush with the side of the device.

5. Step 5: Charge the Device

   Connect the provided USB Type-C cable to the charging port on the bottom of the phone and plug the other end into a power adapter or USB port. The device will begin charging.

Device Overview

Front and Side View

The front features a 5MP front camera. The sides typically house the volume buttons, power button, and the SIM/Micro SD card tray.

Bottom View

The bottom usually contains the USB Type-C port for charging and data transfer, a microphone, and a 3.5mm audio jack.

Back View

The back of the device includes the 5MP main rear camera and a flash lamp.

Specifications

Safety and Compliance

FCC Warning

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Information to user: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

Class B Digital Device Notice: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

RF Exposure Information

This device meets government requirements for exposure to radio waves. The guidelines are based on standards developed by independent scientific organizations through periodic and thorough evaluation of scientific studies. The standards include a substantial safety margin designed to assure the safety of all persons regardless of age or health.

The SAR limit of USA (FCC) is 1.6 W/kg averaged over one gram of tissue. This device was tested for typical body-worn operations with the back of the device kept 10mm from the body. To maintain compliance with FCC RF exposure requirements, use accessories that maintain an appropriate separation distance between the user's body and the back of the device. The use of belt clips, holsters and similar accessories should not contain metallic components in its assembly. The use of accessories that do not satisfy these requirements may not comply with FCC RF exposure requirements and should be avoided. Use only the supplied or an approved antenna.

Body-Worn Operation: For body-worn operation, this device has been tested and meets the FCC/ISEDC RF exposure guidelines when used with a leather case. Users must use this leather case. Use of other leather cases may not ensure compliance with FCC/ISEDC RF exposure guidelines.

Hearing Aid Compatibility (HAC): The mobile phone is hearing aid-compatible. The lowest conversational gain is 18.75dB with a hearing aid and 18.12dB without a hearing aid. The conversational gain is compliant with the waiver (DA 23-914).

EU Restrictions: In all EU member states, operation of 5150-5250 MHz is restricted to indoor use only.

Country of Origin: Made in China

Package Contents

• 1*Phone
• 1*USB-C Cable
• 1*Power Adapter
• 1*Quick Start Guide
• 1*Battery