Type S Tailgate LED Light

Package Contents

• 58" Weatherproof Tailgate Red LED strip
• 4 Way Flat Pin connector
• 7" wire
• Controller hub
• 65" wire

Technical Specification

Working voltage: DC 12V Only

Maximum amperage draw: 2A at 12V

POWER

The Type S Tailgate LED Light kit comes with a 4 Way Flat Pin connector. Simply plug into your truck's trailer light connector. If your truck does not have a 4 Way Flat Pin trailer connector and has 7-prong round trailer plug, please purchase an adapter. If you wish to hardwire, reference plug color code below for wire identification. Hardwire connection should be connected at the trailer plug wire harness.

Note: Refer to your vehicle's service manual for a wire schematic for correct wire placement or you can test the power sources using a multi-meter.

Installation

Note: Depending on the size of your truck, make sure there is no obstruction around the area you want to install the Tailgate LED Light. You may have to remove the tailgate prior to installation.

1. Power your Type S Tailgate LED Light and trigger the Left / Right signal indicator to ensure it is installed in a correct direction. Do this before mounting the Tailgate LED Light onto your vehicle.

Test Left Signal

Test Right Signal

Installation Cont.

1. Thoroughly clean the surface where you desire to apply the Tailgate LED Light with isopropyl alcohol. Dry completely.
2. Peel off the 3M™ tape backer from the Tailgate LED Light strip.
3. Mount the Tailgate LED Light strip.
4. Run the power wire harness between the bumper and the back and plug into the 4 Way Flat Pin trailer light connector. The trailer light connector is located near the tow hitch.

Driver Side

Warning

1. Do not install or use product if it, in any way, impairs the safe operation of your vehicle.
2. Follow manufacturer's instructions to ensure the product is properly & safely installed.
3. Check your state or provincial laws before installing. Vehicle owner must comply with all applicable laws.
4. This product is intended solely for decorative purposes. Manufacturer and Seller assume no liability for installation or use, which are solely the responsibility of the purchaser.
5. This product is not DOT approved and is designed and intended for exterior use only. Not for use in extreme temperature such as under hood applications.
6. The Manufacturer and Seller are not responsible or liable for consequential, incidental, or indirect damages, whether to person or property, resulting from the installation or improper use of this product.

WARNING: This product can expose you to chemicals including DEHP and DINP, which is known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.