TYPE S Universal Rear LED Spoiler Kit

Package Contents

• 24" Wire
• Controller
• 48" Wire
• Fuse
• 1 x Alcohol Wipe
• 50" Spoiler with Controller
• 2 x Adhesion Promoter

Technical Specification

Working voltage: DC 12V only

Maximum amperage draw: 1.6A

Watt: 19.2W

LEDs: 144 x 3528 RGB

Replacement Fuse: 3A

IP Rating of LED Strip: IPX4

Installation

1. Clean the trunk surface thoroughly with isopropyl alcohol. Dry completely.
2. Apply adhesive promoter on the surface.
3. Peel off the 3M™ VHB tape backer and carefully attach the LED Spoiler to the trunk surface.

[Description of image: A hand peeling off the backing from 3M™ VHB tape attached to the spoiler.]

Power Connection

1. Run the wire through the bottom of the trunk.
2. Connect to the car battery or any 12V source.
3. Hub controller hardwire cables are color-coded: RED for POSITIVE (+), BLACK for NEGATIVE (-), and YELLOW for Brake Light POSITIVE (+).
4. Connect the RED cable to the POSITIVE (+) battery clamp. The POSITIVE battery post is usually larger and marked with a PLUS (+) sign, possibly with a RED protective cover.
5. Connect the BLACK cable to the NEGATIVE (-) battery clamp. The NEGATIVE post is usually smaller and marked with a MINUS (-) sign, possibly with a BLACK protective cover.
6. Connect the YELLOW brake light cable to the vehicle's Brake Light POSITIVE (+) wire. Test the brake light to ensure correct connection.

Note: For use with 12V power only.

[Description of diagram: A simplified wiring schematic showing connections to a car battery. Wires are labeled POSITIVE (+), NEGATIVE (-), and OPTIONAL BRAKE LIGHT (+). The wires are color-coded RED, BLACK, and YELLOW respectively.]

Operation

Use the Controller Button:

• Press the button to cycle through 15 color options.
• Press and hold the button for 3 seconds to turn off the spoiler LEDs while keeping the brake light functional.

[Description of diagram: A close-up of the controller button.]

Warnings and Disclaimers

WARNING: Do not install or use the product if it impairs the safe operation of your vehicle. Follow manufacturer's instructions for proper and safe installation. The manufacturer and reseller are not liable for consequential, incidental, or indirect damages resulting from installation or improper use. Check local laws and regulations before installation.

This product is not DOT approved and is designed for interior cabin use only. Avoid extreme temperatures, such as under hood applications.

This product is intended solely for decorative purposes. Check local laws and regulations regarding installation and use. The manufacturer and seller assume no liability for improper installation or use, which are the sole responsibility of the purchaser.

WARNING: This product can expose you to chemicals, including DEHP and DINP, known to the State of California to cause cancer and birth defects or other reproductive harm. For more information, visit www.P65Warnings.ca.gov.

3M™ is a trademark of 3M Company.

Contact & Support:

Email: info@typesauto.com

Website: www.typesauto.com

Responsible Party: TYPE S, 2975 Red Hill Ave., Ste. 100, Costa Mesa, CA 92626, U.S.A. Tel: 1.866.294.9244

© 2021 TYPE S. All rights reserved.

Optional Products

Optional Smart LED products are also available to enhance your experience (sold separately).

• 48" Smart Lighting Deluxe Kit (LM55369)
• 72" Exterior Smart Lighting Kit (LM55878)

[Description of image: A car interior illuminated with colored LED lights, and a car exterior with underglow lighting.]