Thermaltake Toughpower GF1 ARGB 850W/750W/650W User Manual

Warnings and Cautions

Do not unplug the AC power cord when the power supply is in use. Doing so may cause damage to your components.
Do not place the power supply in a high humidity and/or temperature environment.
High voltages exist in the power supply. Do not open the power supply case unless you are an authorized service technician or electrician. Doing so will void the warranty.
The power supply should be powered by the source indicated on the rating label.
Use only genuine Thermaltake modular cables with Thermaltake Cable Management power supply models. Third-party cables might not be compatible and could cause serious damage to your system and power supply. The warranty is voided with the use of third-party cables.
All warranties and guarantees will be voided if you fail to comply with any of the warnings and cautions covered in this manual.

Components Check

TOUGHPOWER GF1 power supply unit
AC power cord
User manual
Mounting screws x 4
ARGB Sync cable x 1

Power Connector Introduction

The following cables are included for connecting your components:

Cable Type	Wattage	Pins
Main Power Connector	N/A	24 Pin
ATX 12V Connector	N/A	8 Pin / 4+4 Pin
PCI-E Connector	N/A	6+2 Pin
SATA Connector	N/A	5 Pin
Peripheral Connector	N/A	4 Pin
Floppy Adapter	N/A	4 Pin

Output Specification

Wattage	AC INPUT	DC OUTPUT
850W	Input Voltage: 100V - 240V~ ; Input Current: 12A max ; Frequency: 47Hz - 63Hz	+3.3V: 22A (120W) +5V: 22A (120W) +12V: 70.9A (850.8W) -12V: 0.3A (3.6W) +5VSB: 3A (15W)
750W	Input Voltage: 100V - 240V~ ; Input Current: 10A max ; Frequency: 47Hz - 63Hz	+3.3V: 22A (120W) +5V: 22A (120W) +12V: 62.5A (750W) -12V: 0.3A (3.6W) +5VSB: 3A (15W)
650W	Input Voltage: 100V - 240V~ ; Input Current: 10A max ; Frequency: 47Hz - 63Hz	+3.3V: 22A (120W) +5V: 22A (120W) +12V: 54.2A (650.4W) -12V: 0.3A (3.6W) +5VSB: 3A (15W)

Installation Steps

Ensure your system is turned off and unplugged. Disconnect the AC power cord from your old power supply.
Open your computer chassis; refer to the instruction manual provided with your chassis.
Install the PSU into the case with the four provided screws.
If your motherboard requires a 24-pin Main Power connector, connect the 24-pin Main Power connector to the motherboard.
Connect the SATA devices (if applicable) to the power supply using the SATA cables provided (e.g., hard drives, CD/DVD drives).
Connect any devices that may use the 4-pin peripheral connectors (e.g., hard drives, CD/DVD drives, or case fans).

Smart Zero Fan System

When the Smart Zero Fan System is activated, the fan will not operate until the power supply reaches approximately 30% of rated load. It is normal if the fan does not operate when the computer is at a low working load.

Riing Duo 14 RGB Fan Features

Lighting Modes

The lighting modes/colors can be changed by pressing the Mode/Color button. You can choose from Wave, Spiral, Flow, Heartbeat, Ripple, Full Lighted, Spectrum Mode, or turn off the LEDs. A long press of the Mode button resets settings to default. The fan also has a built-in memory that can automatically recover the previous lighting mode after restarting the PSU.

ARGB Sync

Lighting effects can be synced through motherboards with the ARGB Sync function. After switching off the PSU, connect the ARGB Sync Cable to the ARGB Sync Header on the PSU and to the +5V ARGB header on the motherboard. Caution: This power supply does not support the +12V RGB header. Install the software provided by your motherboard's vendor (e.g., ASUS AURA SYNC, GIGABYTE RGB FUSION, MSI MYSTIC LIGHT, or AsRock Polychrome software) to choose your preferred lighting theme. The chosen lighting theme will be automatically recovered when the software boots up.

Important: Before connecting the ARGB Sync Cable to the motherboard, please power off the PC and check the positive and negative ends on the connector. Connecting the cable to a wrong header or in a wrong direction can damage the LEDs.

Troubleshooting

Is the power cord plugged properly into the electrical outlet and into the power supply AC inlet?
Please make sure the I/O switch on the power supply is switched to the 'I' position.
Please make sure all power connectors are properly connected to all devices.
If connected to a UPS unit, is the UPS on and plugged in?

If the power supply still fails to function properly after following the above instructions, please contact your local store or Tt branch office for after-sales service. You may also refer to Thermaltake’s website for more technical support: thermaltake.com

Protections

Over Current Protection
Over Voltage Protection
Over Power Protection
Short Circuit Protection

Certifications

The TOUGHPOWER GF1 ARGB series is certified with CE, cTUVus, TUV, FCC, EAC, CCC, BSMI, and S-Mark.

Environmental

Estimated lifespan: > 120,000 hours.

	Thermaltake TOUGHPOWER GF1 ARGB 850W/750W/650W Power Supply User Manual Comprehensive user manual for the Thermaltake TOUGHPOWER GF1 ARGB series power supplies (850W, 750W, 650W), covering safety precautions, component checks, connector details, output specifications, installation steps, fan features, protections, certifications, environmental information, troubleshooting, and support.
	Thermaltake Toughpower GT 850W/750W/650W Power Supply Unit Manual Comprehensive guide for Thermaltake Toughpower GT series power supply units (850W, 750W, 650W), covering safety warnings, component checks, installation steps, output specifications, protection features, and troubleshooting.
	Thermaltake TOUGHPOWER GRAND RGB 850W/750W/650W GOLD (RGB Sync Edition) User Manual and Specifications Comprehensive guide for the Thermaltake TOUGHPOWER GRAND RGB 850W, 750W, and 650W GOLD power supply units (RGB Sync Edition). Includes safety warnings, installation instructions, detailed output specifications, connector information, RGB fan features, troubleshooting tips, and protection details.
	Thermaltake Toughpower GX3 850W / 750W Power Supply Unit Manual Comprehensive guide for the Thermaltake Toughpower GX3 850W and 750W power supply units, covering installation, safety precautions, troubleshooting, output specifications, and protection features.
	Thermaltake Toughpower Grand RGB Gold Power Supply Units - 850W, 750W, 650W Detailed specifications, installation guide, and safety information for Thermaltake Toughpower Grand RGB Gold series power supply units (850W, 750W, 650W). Includes connector types, output specifications, and troubleshooting tips.
	Thermaltake BERLIN 750W / HAMBURG 650W Power Supply Unit Manual and Specifications Comprehensive guide and technical specifications for Thermaltake BERLIN 750W and HAMBURG 650W power supply units, including safety warnings, installation instructions, troubleshooting tips, connector details, and output power specifications.
	Thermaltake TOUGHPOWER GT SNOW 850W/750W Power Supply Unit User Manual User manual and technical specifications for the Thermaltake TOUGHPOWER GT SNOW 850W and 750W power supply units, detailing features, installation, protections, and troubleshooting.
	Thermaltake SMART M 850W/750W/650W Power Supply Unit Specifications Detailed specifications and technical data for the Thermaltake SMART M series of power supply units, including the 850W, 750W, and 650W models. Covers AC input, DC output, maximum current, maximum power, and continuous power for each model.