Thermaltake TOUGHPOWER GT 850W / 750W / 650W

Warnings and Caution

• Do not unplug the AC power cord when the power supply is in use. Doing so may cause damage to your components.
• Do not place the power supply in high humidity and /or temperature environment.
• High voltages exist in the power supply. Do not open the power supply case unless you are an authorized service technician or electrician. Doing so will void the warranty.
• The power supply should be powered by the source indicated on the rating label.
• Make sure all cables are plugged in properly. Loose and improper connections would damage the power supply and your system.
• Please use only genuine Thermaltake modular cables with Thermaltake power supply models. Third-party cables might not be compatible and could cause serious damage to your system and power supply. The warranty is voided with the use of third-party cables.
• All warranties and guarantees will be voided, if failure to comply with any of the warnings and cautions covered in this label.

Components Check

• TOUGHPOWER GT power supply unit
• AC power cord
• User manual
• Mounting screws x 4
• Cable straps x 4

Power Connector Introduction

Output Specification

850W

750W

650W

Installation Steps

1. Open your computer chassis; please refer to the instruction manual provided with your chassis.
2. Install the PSU into the case with the four screws provided.
3. If your motherboard requires a 24pin Main Power connector, please connect the 24pin Main Power connector to the motherboard.
4. 1. For motherboards that only require a 4pin ATX 12V(CPU) connector, please detach a 4pin connector from the 4+4pin ATX 12V connector and connect it to the motherboard. (Either one of the 4pin from the 4+4pin ATX 12V connector will work)
5. 2. For motherboards that requires a single 8pin EPS connector, please use the 4+4pin connector from the power supply.
6. Connect other peripheral power connectors to devices such as hard drives, optical drives, etc.
7. If your graphic card requires PCI-E power connector, please connect corresponding PCI-E connector instructed by your graphic card's user manual. Please note the power supply utilizes an unique 6+2pin PCI-E connector that can be effectively used as a single 8pin or 6pin PCI-E connector. To use it as a 6pin PCI-E connector, please detach the 2pin connector from the 6+2pin connector.
8. Close your computer case and connect the AC power cord to the power supply AC inlet.
9. Attention! When Smart Zero Fan System is turned on, the fan will not operate until the power supply reaches approximately 30% of rated load; It is normal if the fan does not operate when computer is at a low working load.

Protection Features

Over Voltage Protection

Under Voltage Protection

Over Current Protection

Over Power Protection

The power supply shall be shut down and latch off, if the wattage of the power supply is 110% ~ 170% over continuous power.

Over Temperature Protection

Protection temperature is 50 ~ 65°C at 115V and full load.

Short Circuit Protection

Activated when any DC rails short circuited.

EMI & SAFETY

CB, FCC, cTUVus and S-mark certified.

Environments

• Operating Temperature: +0°C to +40°C
• Humidity: 5% to 85% (non-condensing)
• MTBF: > 100,000 hours

Trouble-Shooting

1. Is the power cord plugged properly into electrical outlet and into the power supply AC inlet?
2. Please make sure the I/O switch on the power supply is switched to I position.
3. Please make sure all power connectors are properly connected to all the devices.
4. If connected to a UPS unit, is the UPS on and plugged in?

If the power supply is still unable to function properly after following the above instruction, please contact your local store or Tt branch office for after sales service. You may also refer to Thermaltake's website for more technical support: thermaltake.com