Antarctic Star Beverage and Wine Center

Product Overview

This document is the user manual for the Antarctic Star Beverage and Wine Center, model JC-128UEX. It provides essential information for safe operation, installation, and maintenance.

The appliance is a compact beverage and wine center designed for cooling and storing drinks. It features glass shelves, a tinted glass door, and a touch control panel.

General Safety Rules

Before using your refrigerator, please read this owner's manual carefully. Use this appliance only for its intended purpose as described in this owner's manual.

DANGER: Risk of child entrapment. Before you throw away your old refrigerator or freezer:

• Take off the doors.
• Leave the shelves in place so that children may not easily climb inside.

• The appliance must be correctly installed and connected to the power supply in accordance with the installation instructions before it is used. (See: "Installing Your Beverage And Wine Center").
• The main power supply must be properly grounded.
• This refrigerator must be positioned so that the plug is accessible. Never unplug your unit by pulling on the power cord. Always grasp the plug firmly and pull straight out from the outlet.
• Do not use an extension cord as this can negatively affect the performance of the unit.
• When transporting the refrigerator, keep the unit in the upright position. Do not tilt the appliance beyond 45° or place the unit in an upside-down position. Do not tip over.
• Do not touch the cooled surfaces while the appliance operates, especially not with wet hands, because the skin may stick to the cold surfaces.
• It is recommended that the refrigerator is positioned away from any combustible sources such as gas, petrol, alcohol, lacquer and banana oil, etc. These objects should not be stored in the refrigerator under any circumstances.
• If the unit fails to cool properly, dispose of spoiled food as needed.
• Unplug your unit before cleaning or before making any repairs. NOTE: If for any reason this product requires service, we strongly recommend that a certified technician perform the service. Repairs made by non-qualified personnel will void the warranty.
• Do not defrost the appliance with other electric devices (hair dryer etc.) and never scrape the ice or frost layer with sharp tools. Warning: Do not damage the refrigerant circuit.
• The rating plate is inside the appliance or outside on the rear or side wall.
• This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance.
• Do not run cord over carpeting or other heat insulators. Do not cover the cord. Keep cord away from traffic areas, and do not submerge in water. If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a similarly qualified person in order to avoid a hazard. Repair or replace immediately all electric service cords that have become frayed or otherwise damaged. Do not use a cord that shows cracks or abrasion damage along its length, the plug or the connector end.
• Do not operate your refrigerator in the presence of explosive fumes.
• WARNING -- Do not use flame or catch fire near the unit.
• DANGER - Risk of fire or Explosion. Flammable Refrigerant Used. To Be Repaired Only By Trained Service Personnel. Do Not Puncture Refrigerant Tubing.
• Caution - Risk of fire or Explosion. Dispose Of Property In Accordance With Federal Or Local Regulations. Flammable Refrigerant Used.
• CAUTION – Risk Of Fire Or Explosion. Flammable Refrigerant Used. Consult Repair Manual/Owner's Guide Before Attempting To Service This Product. All Safety Precautions Must be Followed.
• CAUTION – Risk Of Fire Or Explosion Due To Puncture Of Refrigerant Tubing; Follow Handling Instructions Carefully. Flammable Refrigerant Used.

Staple your receipt to your manual. You will need it to obtain warranty service.

Parts and Features

The Antarctic Star Beverage and Wine Center includes the following components:

• 1. Interior Light: Provides illumination inside the unit.
• 2. Glass Shelves (3): Adjustable shelves for organizing beverages.
• 3. Chrome Wire Shelf (1): An additional shelf for storage.
• 4. Adjustable Leveling Legs: Located at the front and rear bottom corners to ensure stability and proper door closure.
• 5. Glass Touch Control Panel: Interface for operating and setting the unit's temperature and features.
• 6. Tinted Double Pane Glass Door: Allows visibility of contents while providing insulation.
• 7. Drip Tray (in back, not shown): Collects condensation.

The control panel features indicators for temperature settings and operational modes.

Installing Your Beverage And Wine Center

Unpacking

1. Remove all packaging material, including foam base and adhesive tape holding accessories inside and outside.
2. Inspect and remove any remaining packing, tape, or printed materials before powering on the unit.

Leveling

• Your beverage and wine center has two leveling legs located in the front corners. Adjust these after placing the unit in its final position to ensure it is level.
• Turn legs clockwise to lower the unit, or counterclockwise to raise it. The door will close more easily when the front leveling legs are slightly extended.

Proper Air Circulation

• Install the unit in a location with proper air circulation and accessible electrical connections for maximum efficiency.
• Recommended clearances: Sides: 2" (50mm), Top: 2" (50mm), Back: 2" (50mm).
• Do not overfill the unit for proper cooling.

Note: If the unit has been tilted, wait 24 hours before plugging it in.

Drip Tray

Ensure the drip tray in the rear of the unit is in the proper position.

Electrical Requirement

WARNING: ELECTRICAL REQUIREMENT - SHOCK HAZARD

• Use a suitable power outlet (115 volts, 15 amps) with proper grounding.
• Avoid using three-prong adapters or cutting off the grounding prong, as this creates a shock hazard.

Installation Limitations

• Do not install in locations not properly insulated or heated (e.g., garages). The unit is not designed for ambient temperatures below 55°F (13°C).
• Select a hard, even surface away from direct sunlight or heat sources (radiators, cooking appliances). Correct any floor unevenness with leveling legs.
• This unit is designed for freestanding installation only; it is not for built-in applications.
• Note: This unit is for indoor use only.

Use of Extension Cord

• Avoid extension cords due to potential safety hazards.
• If an extension cord is necessary, use a 3-wire cord with a 3-blade grounding plug and a matching outlet. The cord's rating must be equal to or greater than the appliance's rating.

Features and Use

Control Panel (Fig. 2)

The control panel allows you to manage the unit's functions.

Initial Setup

1. Plug the unit into an electrical outlet. A beep indicates normal operation. The display will show the internal temperature.
2. The control panel [power-icon] will be active. You must press the [lock-icon] before accessing any control pads.

Control Panel Settings

The adjustable temperature range is 39°F to 56°F. The LED display shows the actual internal temperature. The factory setting is 46°F.

Note: Actual temperature may vary slightly during normal operation.

Control Panel Auto-Lock

The unit has an automatic control panel lock. You can manually activate or deactivate it by pressing the [lock-icon] control pad. To operate any function, press the [power-icon] control pad before making a selection. The lock automatically activates if the panel is not touched for 30 seconds.

Manual Temperature Setting

The temperature can be set between 39°F and 56°F using the [down-arrow] and [up-arrow] pads. The display is in Fahrenheit only.

1. Press the [power-icon] control pad.
2. After the beep, press the [down-arrow] or [up-arrow] pad to increase or decrease the temperature in one-degree increments. The LED readout will update with each change.
3. Once the desired setting is reached, press the [power-icon] control pad.

Interior Light

A soft light complements the unit's look. Simply push the [power-icon] pad to turn the light on, and push again to turn it off. For energy efficiency, keep the light off when not viewing your collection.

Please Note: The light will not activate if the lock button [lock-icon] is "ON".

Shelving and Sounds

Shelving

To remove or replace a full-width slide-out shelf:

1. Gently tilt the shelf up and slide forward until it is completely removed.
2. To replace the shelf, gently slide it back into position.

Normal Operating Sounds

• Boiling water, gurgling sounds, or slight vibrations may occur due to refrigerant circulation.
• The compressor makes operational sounds when cycling on and off.

Proper Beverage And Wine Center Care & Cleaning

Cleaning and Maintenance

Warning: To avoid electric shock, always unplug your beverage and wine center before cleaning. Ignoring this warning may result in death or injury.

Caution: Before using cleaning products, always read and follow manufacturer's instructions and warnings to avoid personal injury or product damage.

General Cleaning

• Prepare a cleaning solution of 3-4 tablespoons of baking soda mixed with warm water. Use a sponge or soft cloth dampened with the solution to wipe down the unit.
• Rinse with clean warm water and dry with a soft cloth.
• Do not use harsh chemicals, abrasives, ammonia, chlorine bleach, concentrated detergents, solvents, or metal scouring pads, as they may damage or discolor the unit.

Door Gaskets

• Clean door gaskets every three months to ensure a proper seal. Gaskets must be kept clean and pliable.
• Applying a light coat of petroleum jelly on the hinge side of the gaskets will help keep them pliable and ensure a good seal.

Defrosting

The unit has a manual defrost system. Surfaces will defrost when the unit is unplugged. Water is channeled to a drip tray on the compressor and evaporates due to heat transfer.

Power Interruptions

• During power interruptions (e.g., thunderstorms), unplug the unit from the AC outlet.
• When power is restored, replug the unit. The unit will revert to the factory setting of 46°F after any power outage; reset your temperature selection.

Vacation and Moving Care

• For long vacations or absences, empty the unit, unplug it, and clean it and the door gaskets according to the "General Cleaning" section. Prop doors open to allow air circulation.
• When moving, always transport the unit vertically. Do not move it lying down, as this could damage the sealed system.

Troubleshooting

Control Panel does not respond

• Check if the control panel [power-icon] is on.

Beverage And Wine Center Does Not Operate

• Check if the unit is plugged in.
• Check if there is power at the AC outlet by examining the circuit breaker.
• Check if the power pad [power-icon] is on.

Temperature appears too warm

• Frequent door openings.
• Allow time for recently added beverages to reach proper temperature.
• Check gaskets for a proper seal.
• Adjust temperature control to a cooler setting.

Temperature is too cold

• If the temperature control setting is too cold, adjust to a warmer setting and allow several hours for temperature to adjust.

Beverage And Wine Center runs too frequently

• This may be normal to maintain constant temperature during high temperature and humid days.
• Doors may have been opened frequently or for an extended period of time.
• Check gasket for proper seal.
• Check to see if doors are completely closed.

Moisture build up on interior or exterior

• This is normal during high humidity periods.
• Prolonged or frequent door openings.
• Check door gaskets for proper seal.

Beverage And Wine Center door does not shut properly

• Level the beverage and wine center.
• Check for blockages.

Contact Information

Thank you for purchasing this product! If you have questions about assembly or operation, are missing parts, or if the product is damaged, please contact customer service.

Customer Service Phone: 213-4467172 (8:30am - 5:30pm P.S.T.)

Address: 9733 Topanga Canyon Blvd. APT310, Chatsworth, CA 91311

Note: Dated proof of purchase is required for warranty service.

Do not return this product to the store.