Product Specifications
| Model | EAN | W | lm | K | (°C) | IP | Projected area / m² |
|---|---|---|---|---|---|---|---|
| ENDURA FLOOD SOLAR SEN REM 10W 840 | 4058075762350 | 10 | 1200 | 4000 | -20...+45 | 65 | 95° 36000 0.047538 |
Product Overview & Dimensions
The ENDURA FLOOD SOLAR SENSOR is a solar-powered floodlight. It weighs 1730g. The dimensions are approximately 313mm in height, 67mm in width, and 194mm in depth. The product includes a remote control for operation.
Installation Guide
Step 1: Mounting the Fixture
Mount the fixture using M8 bolts, with a maximum torque of 30Nm. Ensure all necessary mounting hardware (labeled a, b, c, d, e, f in diagrams) is used. Note that some accessories may not be included.
Step 2: Solar Panel and Battery
Position the solar panel for optimal charging. The product has a battery that cannot be replaced. Charging indicators show 0% to 100% charge, with a typical charging time of 4-6 hours. The sensor has a maximum range of 5 meters.
Step 3: Sensor Adjustment
The motion sensor can be adjusted up to 270° to cover the desired detection area.
Step 4: Installation Steps
Follow the visual steps for installation. This typically involves securing the fixture, connecting any necessary components, and ensuring the light switch button is accessible.
Operation
Step 5: Before First Use
Ensure the product is fully charged before initial use. Place the solar panel in sunlight for approximately 8 hours (indicated by ☀️ ➡️ 2x ➡️ 8h). The product will be in OFF mode initially.
Step 6: Operating the Floodlight
To turn the light ON, press the metal switch down. Use the pull mechanism for the light switch button. The sensor can be adjusted to detect daylight. Use the push buttons on the remote control to select lighting modes and set the sensor to daylight lighting mode.
Working Modes
The floodlight offers several working modes:
- Mode 1: Operates at 100% brightness, then switches to 0% (standby/off).
- Mode 2: Operates at 100% brightness, then dims to 35-75 lm.
- Mode 3: Operates continuously at 35-75 lm.
Sensor Specifications:
- Detection Angle: 120°
- Detection Range: <5 m
- Detection Speed: 0.6-1.5 m/s
- Typical Detection Distance: 4-8m (at <24°C)
- Response Time: 7-17s
Temperature and Light Thresholds:
- Working Ambient Temperature: -20°C to +45°C
- Charging Ambient Temperature: 0°C to +45°C
- Ambient Light-Sensing Threshold: 10-30 LUX
Remote Control Functions
The included remote control features the following buttons:
- ON: Turns the light on.
- SLEEP: Puts the light into a low-power standby mode.
- M1, M2, M3: Programmable modes or preset settings.
- WAKE UP: Wakes the light from sleep mode.
Safety Information & Warnings
⚠️ BATTERY WARNING: KEEP OUT OF REACH OF CHILDREN
Swallowing coin or button batteries can lead to severe chemical burns, perforation of soft tissue, and death. Severe burns can occur within 2 hours of ingestion. Seek immediate medical attention.
Note: Based on BS EN IEC 60086-4:2019, Figure 9.
Symptoms of Battery Ingestion:
It may not be obvious when a battery is swallowed. Symptoms can include:
- Coughing, gagging, or drooling excessively.
- Appearing to have a stomach upset or viral illness.
- Vomiting.
- Pointing to the throat or stomach.
- Pain in the abdomen, chest, or throat; feeling tired or lethargic.
- Being quieter or more clingy than usual, or generally not themselves.
- Loss of appetite or reduced appetite.
- Refusal to eat solid food or inability to eat solid food.
These symptoms may fluctuate. Vomiting fresh (bright red) blood is a specific and critical symptom requiring immediate medical help.
General Vigilance: Be vigilant with "flat" or spare button or coin batteries in the home and in products that contain them.
Disposal and Compliance
The product bears CE and EAC markings, indicating compliance with relevant standards. It is also rated IP65 for dust and water resistance. The packaging may include PAP markings.
Recycling Information (France):
The device and its accessories are recyclable. Please deposit them at designated collection points:
- Deposit in store (À DÉPOSER EN MAGASIN)
- Deposit at a recycling center (À DÉPOSER EN DÉCHÈTERIE)
- Find collection points at: www.quefairedemesdechets.fr
Manufacturer Information:
LEDVANCE GmbH
Steinerne Furt 62
86167 Augsburg, Germany
www.ledvance.com
