TurboTronic TT-X12 Handheld Vacuum Cleaner

Warnings and Safety Precautions

Read the instruction manual carefully before use! Keep this instruction manual for future use.

• Children should be supervised to ensure that they do not play with the appliance.
• This appliance is designed for domestic use only.
• Do not pull on the connection cord, but rather on the plug, to separate the appliance adaptor from the mains.
• Do not use outdoors.
• Do not leave the appliance unattended when it is switched on, as this may be a source of danger.
• Stand the appliance on a table or flat surface.
• If the supply adaptor is damaged, it must be replaced by a qualified person in order to avoid a hazard.

Following objects are strictly banned, otherwise the vacuum cleaner will be damaged or fire calamity will be caused, which bring such accidents as human body injuries:

• Do not pick up large or sharp broken items such as glasses.
• Do not pick up reactive liquids (solvent, corrosive, detergent...).
• Do not pick up inflammable or explosive substances such as gasoline or alcohol.

• Check the device and connections regularly for visible damage.
• The device must not be used if the housing is damaged or other damage is present.
• Never attempt to open the device or the mains adapter yourself or to replace the connecting cable. Always have repairs to the device carried out by a specialist workshop.
• There is considerable danger to the user if repairs are faulty.
• Do not trap the mains power adapter cable and when using the adapter, pay attention to where the cable is to prevent any danger of tripping over it.
• Keep the cable away from heated surfaces (e.g., cooker and other hot surfaces).
• Do not touch the mains adapter and cable with wet hands.
• Do not point the vacuum cleaner at persons or animals when in operation.
• Only use the mains adapter in a clean and dry environment.
• Only use the device with the accessories supplied.
• Please keep these instructions in a safe place.
• Use only with the provided adaptor.
• This appliance is not intended for use by children or the infirm, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
• When vacuuming liquid spills, ensure that the dust canister does not become overfilled, as this will block the filters and may seriously damage the appliance.

Description

Diagram showing the main handheld vacuum unit, a charging base with mounting hardware, a power adapter, and accessories including a crevice tool and a rubber tool. The components are labeled with numbers 1 through 8.

• 1. Dust tank
• 2. Dust tank release button
• 3. Indicator light
• 4. On/off switch button
• 5. Crevice tool
• 6. Rubber tool
• 7. Charging base
• 8. Adapter

Charging

Attention: You may fix the charging base on wall or put on the flat surface.

Put the appliance on the charging base. Insert the adaptor into the mains socket. Always make sure that the vacuum is turned off before connecting to the power adaptor.

The indicator light in red color will come on and keep flashing once the device has made contact with the adaptor.

In order to ensure that it is always ready for use, the device should be left on charge with adaptor when not being used.

The adaptor may become warm during charging - this is normal.

Illustration of the charging process: the charging base is shown mounted on a wall, the vacuum cleaner is placed on the base, and the power adapter is plugged into a wall socket.

Indication Light

1. When charging the appliance, the indication light in red color will come on and keep flashing.
2. When fully charged, the indication light will keep on in red color.
3. When using the appliance, the indication light will be in green color.
4. When the battery is weak, the indication light in green color will keep flashing.

Use and Function

Do not connect the adaptor when using the appliance.

You should regularly check that the nozzle is clean, as any foreign object may scratch sensitive floors.

1. Insert the crevice nozzle (6) into the main unit when cleaning tables, cars, corners, sofas, carpets, etc.
2. Insert the rubber nozzle into the main unit when cleaning water.
3. Start the device by pushing the on/off button (4) upward.
4. Pushing the on/off switch button (4) downward to turn off the device.

Diagram illustrating the use of accessories. The main vacuum unit is shown with the crevice nozzle attached. Separate images show the main unit, the crevice tool, the rubber tool, and a filter.

Emptying/Cleaning

Careful cleaning of the dust container and filters.

1. Remove the whole dust bin by pressing the release button and take the dust container off. (Refer to pic1)
2. Pull out the filters and empty the contents of the dust container into a suitable vessel or bag. (The filter can be shaken clean or cleaned and rinsed using warm water. Make sure that the parts are dry before they are re-installed.) (Refer to pic2)
3. Empty the dust tank. (Refer to pic3)
4. Wash the filters under water. (Refer to pic4)
5. Re-install the components.

Important: Make sure that the parts are dry before they are re-installed.

Put the filter into the dust container. Assemble the dust bin to the motor unit following the opposite procedures for detaching the dust bin.

A series of four images illustrating the cleaning process: pic1 shows detaching the dustbin; pic2 shows removing filters from the dustbin; pic3 shows emptying the dustbin; pic4 shows washing the filters under water.

Disposal of Old Electrical Appliances

The European directive 2002/96/EC on Waste Electrical and Electronic Equipment (WEEE) requires that old household electrical appliances must not be disposed of in the normal unsorted municipal waste stream. Old appliances must be collected separately in order to optimize the recovery and recycling of the materials they contain, and reduce the impact on human health and the environment.

A symbol depicting a waste bin with wheels crossed out, indicating proper disposal requirements, reminds you of your obligation that when you dispose of the appliance, it must be separately collected.

Consumers should contact their local authority or retailer for information concerning the correct disposal of their old appliance.

Limited Warranty

Limited Warranty applies to purchases made from authorized retailers of TurboTronic®.

TurboTronic® Warranty coverage applies to the original owner and to the original product only and is not transferable.

TurboTronic® warrants that the unit shall be free from defects in material and workmanship. Limited Warranty applies only when it is used under normal household conditions and maintained according to the requirements outlined in the Owner's Guide, subject to the following conditions and exclusions:

What is covered by this warranty?

1. The original unit and/or non-wearable parts deemed defective, in TurboTronic® sole discretion, will be repaired or replaced.
2. TurboTronic® reserves the right to replace the unit with one of equal or greater value.

What is not covered by this warranty?

1. Normal wear and tear of wearable parts (such as blending vessels, lids, cups, blades, blender bases, removable pots, racks, pans, etc.), which require regular maintenance and/or replacement to ensure the proper functioning of your unit, are not covered by this warranty.
2. Any unit that has been tampered with or used for commercial purposes.
3. Damage caused by misuse, abuse, negligent handling, failure to perform required maintenance (e.g., failure to keep the well of the motor base clear of food spills and other debris), or damage due to mishandling in transit.
4. Consequential and incidental damages.
5. Defects caused by repair persons not authorized by TurboTronic®. These defects include damages caused in the process of shipping, altering, or repairing the TurboTronic® product (or any of its parts) when the repair is performed by a repair person not authorized by TurboTronic®.
6. Products purchased, used, or operated outside Europe.

Illustrations may differ from actual product.

We are constantly striving to improve our products, therefore the specifications contained herein are subject to change without notice.

TurboTronic® and Z-Line® are registered trademarks of Z-GLOBAL B.V.B.A®.

Printed in PRC.