Vornado Refresh 8 Whole Room Circulator

Owner's Guide

Model: Refresh 8

5 Year Satisfaction Guarantee

Read and Save These Instructions

Visit vornado.com

Our Commitment

We expect this product to be perfect. If it is not, we will make it right.

Contact us at: help@vornado.com or 800-234-0604

Important Safety Instructions

This owner's guide and any additional inserts are considered part of the product. They contain important information about safety, use, and disposal. Please familiarize yourself with all operating and safety instructions. Keep all documents for future reference and pass them on with the product to any future owner. View the most current version at www.vornado.com.

Intended Use

This product is intended to circulate air in indoor living spaces only in the United States. It is not intended for commercial or industrial use. The manufacturer assumes no responsibility for damage or injury due to unauthorized use or product modification. Failure to follow these directions will void the product warranty.

⚠️ WARNING: Risk to Children and Impaired Persons

Supervision is required during installation, operation, cleaning, and maintenance by children 12 years of age and younger, or individuals with reduced physical, sensory, or mental capabilities. Children should be supervised to ensure they do not play with the appliance, its parts, or packaging material.

⚠️ INSTALLATION WARNING—To reduce risk of fire, electrical shock, and injury to persons:

⚠️ SAFE USE WARNING—To reduce risk of fire, electrical shock, and injury to persons:

⚠️ SERVICING WARNING—To reduce risk of fire, electrical shock, and injury to persons:

User Servicing Instructions (Fuse Replacement)

  1. Using the product controls, turn off the appliance.
  2. Grasp the plug (not the cord) and disconnect from the outlet.
  3. Risk of Fire: Replace fuse only with a 2.5 Amp, 125 Volt fuse approved by Vornado Consumer Service. Contact Vornado Consumer Service for an authorized replacement fuse.
  4. Once the replacement is received, use a small flat-head screwdriver to slide open the fuse cover (located on the plug) (See description of Figure A).
  5. Remove the fuse by using the screwdriver to gently lift each end of the fuse (See description of Figure B).
  6. Install the replacement fuse by using the screwdriver to gently push each metal end into the receptacle one at a time. Do not push on the center of the fuse, as it is fragile and may break.
  7. Slide the fuse cover closed using the screwdriver. Ensure the cover fits completely in the plug, with no part sticking out (See description of Figure C).
  8. Plug your appliance into the outlet and turn the power on.
  9. If the replacement fuse blows, a short-circuit may be present. Discard the product or return it to an authorized service facility for examination and/or repair.

Risk of fire. Do not replace the attachment plug. It contains a safety device (fuse, AFCI, LCDI) that should not be removed. Discard the product if the attachment plug is damaged.

SAVE THESE INSTRUCTIONS

Features

45° Directable Airflow: Direct the airflow where you want it.

Scent-Ready Pad Cap

Scent-Ready Pads (10 Included)

Removable Grille and Blade

Tightening Knobs (2): Note: Over time, the knobs may need tightening.

Support Arm: For 360° swivel.

Base

Controls:

  • I - LOW FAN SPEED
  • II - MEDIUM FAN SPEED
  • III - HIGH FAN SPEED
  • O - OFF

⚠️ WARNING: Choking Hazard. Keep small parts like silicone feet away from children and pets.

⚠️ WARNING - Pinch Hazard: Between Fan Body and Arm Support. Ensure knob is secured and fully tightened prior to moving product.

Getting Started

Scent-Ready Pad

This pad is unscented. To add your favorite essential oil to the pad, please follow these instructions:

  1. Remove the Scent-Ready Pad Cap.
  2. Add a few drops of essential oil to the pad. NOTE: Use caution when adding essential oil. Do not oversoak the scent pad.
  3. Install Scent-Ready Pad.
  4. Replace the Scent-Ready Pad Cap.

⚠️ WARNING: The material used on the scent-ready pad cap and pad holder is designed specifically for use with essential oils. To maintain product longevity, do not put essential oils anywhere else on the product.

Cleaning

Grille Removal [Screwdriver Required]

⚠️ WARNING: To reduce the risk of electrical shock and injury to persons, unplug the circulator before removing the grille.

  1. Remove the screw located between the ribs of the Shroud at the 6 o'clock position. Rotate the Grille counterclockwise and pull directly out to remove.
  2. Dust or wash Grille with mild dishwashing soap. Do not place the Grille in the dishwasher, as excessive heat can distort the plastic.
  3. To reattach: Align the screw boss on the bottom backside of the Grille slightly to the right of the screw boss on the Shroud.
  4. Ensure notches on top of the Grille are aligned with indents on the Shroud.
  5. Rotate the Grille clockwise until it "clicks" into place.
  6. Replace the screw.

[Tip]: Use the brush attachment on your household vacuum cleaner to vacuum any accumulated dust off the Grille and Shroud.

Blade Removal

⚠️ WARNING: To reduce the risk of electrical shock and injury to persons, unplug the circulator before removing the blade.

  1. Unscrew the blade cap by holding the blade in place with one hand while turning the blade cap clockwise. Pull the blade straight out from the shaft.
  2. Wipe the blade with a damp cloth. If your circulator is used in a greasy environment (e.g., kitchen), mild soap or a common household cleaner may be necessary. Do not use solvents. Do not place the blade in the dishwasher, as excessive heat can distort the plastic.
  3. To reattach: Ensure the flat side of the shaft aligns directly with the corresponding flat side on the blade's socket. Push the blade all the way onto the shaft until it bottoms out and the threads on the shaft are completely through the blade socket. Do not use a hammer, as this could result in bearing damage.
  4. Reinstall the blade cap and ensure it has been firmly tightened.

Troubleshooting

ProblemPossible Cause and Solution
The unit fails to power on.
  • Unit is not plugged in. Plug Power Cord into electrical outlet.
  • Ensure unit fan speed setting is selected.
  • Unit is damaged or in need of repair. Cease usage and unplug. Contact Consumer Service for assistance.
  • Plug fuse has blown. Replace fuse. See USER SERVICING INSTRUCTIONS.
  • The outlet is worn or damaged. Try another outlet or contact a qualified electrician.
Airflow is weak or slow.
  • Unit set to a low speed setting. Adjust to a higher speed setting.
  • Allow the unit to fully circulate the air throughout the room; this may take several minutes.
  • Ensure all air inlets and outlet grille are unobstructed.
Fan Body will not stay in desired position.Tighten the knob located on the Fan Body until the Fan stays in the desired position.
GFCI has tripped.Under certain conditions, a reset GFCI (Ground Fault Circuit Interrupter) outlet may trip when changing speeds on a Vornado circulator. In this event, change to an outlet not connected to a GFCI device. It could also indicate a weak or defective GFCI outlet. Contact a qualified electrician to check the GFCI outlet.

Warranty

We expect this product to be perfect. If you're not satisfied with this product, let us know.

We're Here To Help

Phone: 800.234.0604

Website: vornado.com

Email: help@vornado.com

Vornado Air LLC ("Vornado") warrants to the original consumer or purchaser this Vornado® Whole Room Circulator ("Product") is free from defects in material or workmanship for a period of five (5) years from the date of purchase. If any such defect is discovered within the warranty period, Vornado, at its discretion, will repair or replace the Product at no cost.

For Warranty Service:

Call 1-800-234-0604 or email help@vornado.com to obtain a Return Authorization ("RA"). Please have or include your Product's model number and serial number, as well as your name, address, city, state, zip code, email, and phone number when contacting Vornado for warranty service. To file a contactless warranty claim, visit vornado.com/contact-us.

After receiving the RA form, ship your Product to: Vornado Air LLC, Attn: Warranty & Repair, 415 East 13th Street, Andover, KS 67002. Please allow 2-3 weeks for warranty service and return of your Product.

Warranty Exclusions: This warranty does not apply to defects resulting from abuse, modification, alteration, mishandling, improper maintenance, commercial use, or repair/service by anyone other than Vornado. It also excludes damages occurring in shipment or those attributed to acts of God. Improper product use, including using external devices that alter voltage/frequency or shipping to unintended countries, will void warranties. Unauthorized modification, repair by unauthorized centers, or use of non-approved replacement parts are not recommended and not covered.

Limitation of Liability: REPAIR OR REPLACEMENT AS PROVIDED UNDER THIS WARRANTY IS THE EXCLUSIVE REMEDY. VORNADO SHALL NOT BE LIABLE FOR ANY INCIDENTAL OR CONSEQUENTIAL DAMAGES. IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE ARE LIMITED IN DURATION TO THE DURATION OF THIS WARRANTY. Some states may not allow limitations on implied warranties or consequential damages.

This warranty gives you specific legal rights, and you may have other rights that vary from state to state.

All company names and product names are trademarks of their respective owners. Specifications are subject to change without notice.

Designed, engineered, and supported in Andover, KS.

© 2024 Vornado Air LLC Andover, KS 67002. U.S. Patent Pending.

Models: Refresh 8 Air Flow with Aromatherapy, Refresh 8, Air Flow with Aromatherapy, Flow with Aromatherapy, with Aromatherapy

File Info : application/pdf, 13 Pages, 3.39MB

PDF preview unavailable. Download the PDF instead.

REFRESH8

References

Adobe PDF Library 17.0 Adobe InDesign 19.4 (Macintosh)

Related Documents

Preview Vornado 293HD Whole Room Circulator Owner's Guide and Safety Instructions
Comprehensive owner's guide for the Vornado 293HD Whole Room Circulator, covering essential safety instructions, product features, setup, cleaning procedures, troubleshooting tips, and warranty information.
Preview Vornado Whole Room Circulator EX051 HD & EX061 HD Owner's Guide
Owner's guide for Vornado Whole Room Circulator models EX051 HD and EX061 HD, detailing safety, features, operation, cleaning, troubleshooting, and warranty information.
Preview Vornado TRANSOM Window Circulator Owner's Guide & Manual
Comprehensive owner's guide for the Vornado TRANSOM Window Circulator. Learn about safety, features, installation, operation, cleaning, troubleshooting, and warranty. Get the most out of your Vornado fan.
Preview Vornado Whole Room Circulator Owner's Guide
Comprehensive owner's guide for Vornado Whole Room Circulators, including safety instructions, features, setup, cleaning, troubleshooting, and warranty information for models 1303, 5303, 6303, 6803, 7503, and 7803.
Preview Vornado Whole Room Circulator Owner's Guide - Models 160, 360, 460, 560, 660
Owner's guide for Vornado Whole Room Circulators, including models 160, 360, 460, 560, and 660. Provides instructions on operation, safety, cleaning, and troubleshooting for optimal whole room air circulation.
Preview Vornado Model 80 Whole Room Circulator Use & Care Guide
Comprehensive use and care guide for the Vornado Model 80 Whole Room Circulator, detailing features, controls, cleaning procedures, troubleshooting tips, and warranty information.
Preview Vornado OSCR32 Tower Circulator Owner's Guide
Comprehensive owner's guide for the Vornado OSCR32 Tower Circulator, detailing safety instructions, features, operation, assembly, troubleshooting, and warranty information.
Preview Vornado OSC73 Oscillating Tower Circulator Owner's Guide | Safety, Features, How-To
Comprehensive owner's guide for the Vornado OSC73 Oscillating Tower Circulator. Includes safety instructions, features, setup, operation, cleaning, troubleshooting, and warranty information.