IKEA MALM Dressing Table

Important Safety Information

WARNING: Furniture tip-over can cause serious or fatal crushing injuries. ALWAYS secure this furniture to the wall using the provided tip-over restraints.

To further reduce the risk of serious injury and death from tip-overs:

• Place heaviest items in the lower drawer.
• Do not set TVs or other heavy objects on top of this product.
• Never let children climb or hang on drawers, doors, or shelves.

This safety warning is provided in multiple languages throughout this document.

Tools and Hardware Overview

The following tools and hardware are typically required for assembly:

• Screwdriver (Phillips head)
• Hammer
• Drill with drill bits (e.g., Ø 8 mm, Ø 3 mm)
• Measuring tape
• Level
• Wall mounting hardware (screws and plugs, specific types depend on wall material)

Refer to the hardware list for specific part numbers and quantities.

Assembly Steps

Step 1: Prepare Base and Sides

Attach the side panels to the base panel using the provided screws and dowels. Ensure correct orientation as shown in the diagram.

Step 2: Attach Drawer Runners

Fix the drawer runners to the inside of the side panels using screws. Pay attention to the correct placement and orientation of the runners.

Step 3: Insert Dowels

Insert wooden dowels into the pre-drilled holes on the relevant panels, as indicated.

Step 4: Attach Back Support

Secure the back support panel to the assembled frame using screws.

Step 5: Prepare Drawer Box Sides

Attach drawer runners to the sides of the drawer box components using screws.

Step 6: Attach Wall Mounting Brackets

Secure the wall mounting brackets to the top rear edge of the dressing table frame using screws.

Step 7: Place Top Surface

Carefully place the top surface panel onto the assembled frame, aligning it with the pre-drilled holes.

Step 8: Secure Top Surface

Fasten the top surface to the frame using screws, often accessed from underneath or through specific access points.

Step 9: Final Frame Securing

Ensure all connections are tight and the frame is stable. Some steps may involve cam locks or similar fasteners.

Step 10: Attach Drawer Slides to Frame

Attach the corresponding drawer slides to the inside of the dressing table frame, aligning them with the previously attached runners.

Step 11: Drawer Box Assembly

Assemble the drawer box components using dowels and screws. This typically involves attaching the front, back, and side panels of the drawer.

Step 12: Secure Drawer Box

Fasten the drawer box components together securely.

Step 13: Attach Drawer Slides to Drawer Box

Attach the remaining parts of the drawer slides to the assembled drawer box.

Step 14: Insert Drawer

Carefully slide the assembled drawer into the dressing table frame, engaging the runners.

Step 15: Final Adjustments

Make any necessary adjustments to ensure the drawer slides smoothly and is properly aligned.

Step 16: Wall Mounting Instructions

Crucial Step for Safety: Secure the dressing table to the wall using the provided tip-over restraints and appropriate wall fixings. The type of screw and plug depends on your wall material:

• Solid Walls (A): Use screws without plugs, or appropriate plugs if required by the screw type.
• Hollow Walls (B): Use screws with suitable plugs designed for hollow walls.
• Solid Wood (C): Use screws without plugs.

If you are uncertain about your wall type or the correct fixings, seek professional advice. The diagrams show examples of drilling and fixing for different wall types.

Refer to the IKEA website for more detailed wall mounting guidance: www.IKEA.com/secure-it

Product Care

Wipe clean with a damp cloth. Wipe dry with a clean cloth.