Anko Microphone Boom Arm

To ensure optimum performance and safety, please read these instructions carefully before operating this product.

Product Feature

• The bracket corner adopts high-quality screws, which can adjust the angle up and down, and the maximum height can reach around 75cm.
• The table mount base can be clamped to a table with a thickness of about 6cm. This is suitable for tables with a thickness of less than 6cm.

How to install

Step 1: Secure the Base

Take the product out of the box. Place the stand base on the table and rotate it to tighten.

(Diagram description: A clamp mechanism, designed to attach to a table edge, is shown. It features a tightening screw and a base plate. Text indicates 'Suitable for tables with a thickness of less than 6cm'.)

Step 2: Attach the Arm

Fix the microphone stand arm onto the base. Rotate the nut to secure the stand.

(Diagram description: The microphone arm is shown being connected to the base. A nut is depicted, with an arrow indicating rotation to tighten the arm to the base.)

Step 3: Adjust and Tighten

Rotate the screws to adjust the arm to a suitable position, then tighten the screws.

(Diagram description: The microphone arm is shown in multiple positions. Arrows indicate rotational capabilities: 360° at the base connection, 180° at one joint, and 270° at another. Text states 'Loosen the screws to adjust'.)

Step 4: Position the Rod

Adjust the position of the rod and tighten the screws.

(Diagram description: A close-up of a joint on the microphone arm. Screws are shown, with an instruction to tighten them after adjusting the rod's position.)

Step 5: Mount the Microphone

Place the handheld microphone (not included) onto the microphone clip.

(Diagram description: A microphone clip is shown. A microphone is being inserted into the clip. Text clarifies that microphones are 'Not included'.)

Step 6: Attach Pop Filter

Attach the pop filter to the microphone stand and tighten the screws to complete the installation.

(Diagram description: A pop filter, attached to a flexible arm, is being connected to the microphone stand. Screws are indicated for tightening to complete the installation.)

Important Note

Please ensure the screws on these three parts are tightened before use.

(Diagram description: Three close-up views illustrate key tightening points: one shows screws on the arm joint being tightened, another shows screws on a different arm joint being tightened, and the third shows the table clamp being rotated and tightened.)