Innokin ARES-2 MTL RTA: User Manual

Product Overview

The Innokin ARES-2 MTL RTA is a rebuildable tank atomizer designed for a satisfying mouth-to-lung vaping experience. It is part of the Platform series, a collaboration featuring P. Busardo and Vapingreek.

Important Safety Information & Warnings

[Warning] This product is intended for use by adults of legal smoking age only.

This product has not been evaluated by the Food and Drug Administration and is not intended to treat, mitigate, prevent, or cure any disease or condition. It is not intended for use as a smoking cessation device.

This device may be used with e-liquids that contain nicotine. It should not be used by children, women who are pregnant or breastfeeding, or persons with or at risk of heart disease, high blood pressure, diabetes, or taking medicine for depression or asthma, or who otherwise may be sensitive to nicotine.

The ARES-2 RTA includes small parts, such as the drip tip and screws. Always keep any small parts out of reach of children and pets to prevent swallowing or other harm.

Technical Guidelines:

• Do not use a coil at a resistance lower than your device can handle.
• A basic understanding of battery safety and Ohm's Law is recommended before building this atomizer.
• The included coils are 1 Ohm Kanthal coils.
• For additional and more detailed information, including building your own coils, please refer to instructional videos (e.g., via QR code if provided in original packaging).

Compliance: CE, FC, ROHS

ARES-2 RTA Components

The Innokin ARES-2 RTA consists of the following parts:

• Drip Tip
• O-Ring
• Top Cap / Sliding Top Fill Cap
• Top Cap O-Ring
• Bell Chamber
• Glass
• Post Screws
• Base / Build Deck
• Base O-Ring
• Air Flow Control

Assembly and Filling Guide

1. Step 1: Access the Build Deck

   Unscrew the bottom cap to access the build deck. You can also adjust the Air Flow Control at this stage.

2. Step 2: Mount the Coil

   Mount the pre-built coil or a coil you have created onto the build deck as shown. Tighten the coil using the post screws and the included tool. Trim the coil leads close to the posts to prevent a short circuit. Ensure the coil leads do not touch the bell chamber.

3. Step 3: Wick the Coil

   Wick the coil with cotton. For thicker VG liquids, less cotton is generally required compared to thinner PG liquids. Cut the cotton so that it barely touches the bottom of the tank.

4. Step 4: Prime the Coil

   Lightly prime the coil with e-liquid to help it get started and to facilitate the setting of the wick into the wick channels.

5. Step 5: Replace the Build Deck

   Screw the build deck back into the tank securely.

6. Step 6: Fill the Tank

   Remove the drip tip. Press the "PUSH TO FILL" area in the direction of the arrow [→] to slide open the top cap and fill with e-liquid.

7. Step 7: Adjust Airflow and Enjoy

   Adjust the airflow to a comfortable draw and enjoy your vape!