GAPERHULT Extendable Table

Tools and Important Information

Tools Required: ?️ [Phillips screwdriver], [Flathead screwdriver]

Assembly Notes:

• Follow all steps carefully.
• Pay attention to the orientation of parts and use the correct hardware for each step.
• If you encounter difficulties or have questions, please refer to the IKEA website or contact IKEA customer support. ?

General Warnings:

• ❌ [Do not force parts together.]
• ❌ [Ensure correct orientation of components as shown in diagrams.]
• ? [Some steps may require two people for safe assembly.]

Parts List

Assembly Steps

Step 1

Attach four large metal brackets (122483) to the base frame. Secure each bracket using four screws (100325). [Diagram shows bracket being screwed into place.]

Step 2

Attach two metal pieces (GAT002) to the side supports. Use two screws (109598) for each piece. ❌ [Warning: Do not use screw 109566 for this step.]

Step 3

Attach leg support pieces to the frame. Each connection uses one screw (109566) and one dowel (101350). ❌ [Warning: Do not use screw 109598 for this step.]

Step 4

Assemble drawer slide components. Insert eight dowels (101350) into four sets of slide parts. [Diagram shows dowels being inserted into slide pieces.]

Step 5

Insert the assembled drawer slides into the main frame. Arrows indicate the direction of insertion. ❌ [Warning: Ensure correct orientation of the slides.]

Step 6

Attach four additional components to the drawer frame. Secure them using four screws (100325). [Diagram shows components being screwed into the frame.]

Step 7

Prepare the leg components. Insert four cylindrical parts (110912) into the leg pieces. Then, screw in two long bolts (100037) into each leg component, for a total of eight bolts. [Diagram shows bolts being screwed into leg parts.]

Step 8

Attach the four assembled leg structures to the main frame. Arrows indicate the connection points. [Diagram shows legs being attached to the base.]

Step 9

Secure the large metal brackets (122483) to the leg assembly. Use nuts (100712) and washers (100843) for each bracket. The provided tool (120202) is used for tightening. [Diagram shows brackets, nuts, and washers being assembled.]

Step 10

Attach a side panel to the frame. An arrow indicates the panel being placed or folded into position. [Diagram shows side panel attachment.]

Step 11

Extend the table top sections. Arrows show the central leaf sections sliding outwards from the main circular halves. [Diagram shows table top extension.]

Step 12

Attach the extended table top sections to the base frame. Arrows show the sections sliding into place and securing. A close-up view illustrates a locking mechanism engaging. [Diagram shows table top attachment and locking.]

Step 13

Attach the main table top to the base frame. Use eight screws (100325). ? [Informational icons show alignment guides and washer placement.]

Step 14

Secure the table top further by attaching sixteen screws (109566) into pre-drilled holes. [Diagram shows screws being inserted.]

Step 15

Detail view of a locking mechanism engaging to secure the table top sections. [Diagram shows locking mechanism.]

Step 16

Attach two additional brackets (GAT003) to the underside of the table. Use screws (109566) for attachment. The diagram indicates the table should be flipped over for this step. [Diagram shows bracket attachment and table flipping.]

Step 18

Extend the table top sections outwards. Arrows indicate the movement. [Diagram shows table top extension.]

Step 19

Raise the extended table top sections. Arrows indicate the upward movement. [Diagram shows table top sections being lifted.]

Step 20

Place the central leaf into the extended table. An arrow shows the leaf being inserted. [Diagram shows leaf insertion.]

Step 21

Extend the table top sections further outwards. Arrows indicate the movement. A close-up view illustrates a locking mechanism engaging. [Diagram shows final table top extension and locking.]