Furrion Vision S Side Cameras & Rear Camera with Marker Light

Prepare

1. Ensure that all items in your package match those shown in the 'What's in the box' section on the packaging box.
2. Before installation, please read and understand all the important safety-related instructions from the online user manual.
3. Prepare tools you may need, including #1 and #2 Phillips head screwdrivers, sealant, insulation tape, pencil and/or a 5/8" hole saw (needed only when drilling a new hole).

Mount Marker Light

Note: Skip this section if your RV is pre-installed with a bracket for camera installation.

IMPORTANT: Before any installation and wiring operation, remove the key from the ignition and isolate the 12V / 24V power source.

Always seek professional assistance if you are unsure about the installation and wiring operation.

1. Determine the mounting location on your RV. Ensure that there is no obstacle blocking the camera view. To avoid drilling new holes, you are recommended to replace the original marker lights with Furrion products directly as shown below:
• For rear camera position: Location of the original rear marker light at the top center on the rear of your RV. To accommodate the camera, ensure that there is at least 7.5" space between the central points of the two adjacent marker lights.
• For side camera position: Location of the original side marker lights (as front as possible & the height from ground to the middle of the trailer).

Note: The fifth-wheel shown below is for reference only. You can mount Furrion Vision S products onto various types of long vehicles such as travel trailer or Class A/B/C motorhomes.

[Diagram showing rear camera position and side camera position]

Step 2: Remove the lens cover and detach the camera from the marker light bracket (right side camera shown).

[Diagram showing removal of lens cover and camera from bracket]

Step 3: Remove the original marker light from the corresponding location.

Step 4: Connect the bare ends of the power cable on the back of the bracket to the nearest 12V / 24V power supply:

• Red (V+_Camera): to the positive wire of the running light circuit;
• Black (GND): to ground;
• Yellow (Trigger): to left/right turn signal [only available for LED versions];
• Brown (V+_Lamp): to positive wire of the running light circuit;

[Diagram showing a typical 7-way connection with labels for each wire color and function]

Note: This image is only for identifying the color code of the signal wires and the user does not have to route the trigger wires to 7-way.

Note: Ensure that the fuse on the connected power line provides additional 1A fusing current for the camera. Ensure proper cable isolation for all bare ends (e.g., by using insulation tape).

Furrion Innovation Center & Institute of Technology
52567 Independence Ct., Elkhart, IN 46514, USA

©2007-2020 Furrion Ltd. Furrion® and the Furrion logo are trademarks licensed for use by Furrion Ltd. and registered in the U.S. and other countries.

Patents pending (FCE48TASL)

IG-FCM00009 V2.0