Tala Knuckle Table Lamp Installation Guide

Before Starting

Please read instructions thoroughly before installation and keep them for future reference. Please take extreme care when dealing with electrical equipment. ⚠️

Important

Bulb must be installed in fixture before turning on.

Warning

Ensure power is turned OFF before inserting plug. ⚠️

Care and Cleaning

We recommend cleaning with a soft dry cloth. Do not use abrasive materials as these will damage the finish of the product. Do not use alcohol or other solvents.

Warranty and After-Care

This product has a two-year warranty. If there appears to be a functional defect with the product during this time, please contact our team at customerservice@tala.co.uk.

Please note, the flexible cable attached to this luminaire cannot be replaced; if the cable is damaged, recycle the luminaire and seek a replacement.

Product Variants

For Indoor Use Only:

• SKU - OAK-KT-01-US
• SKU - OAK-VORN-I-KT-01-US
• SKU - WALT-SPHR-IV-KT-01-US
• SKU - BLOAK-KT-01-US
• SKU - BLOAK-VORN-I-KT-01-US
• SKU - OAK-SPHR-IV-KT-01-US
• SKU - WALT-KT-01-US
• SKU - WALT-VORN-I-KT-01-US
• SKU - BLOAK-SPHR-IV-KT-01-US

Certifications

IP20 Rated, 120V, ETL Listed by Intertek (4008732).

Installation Steps

Step 1: Install Bulb

Insert your bulb into the top of the lamp, rotating clockwise until tight. Take care not to tighten too much to avoid breakage. ?

Step 2: Connect to Power

Insert the lamp plug into your chosen wall socket, making sure the power is switched off. ?

Step 3: Power On and Adjust

Switch the power on and rotate the dial on your dimmer until the bulb lights up. Adjust the dimmer for your desired light output. ?

Join the Community

Contact: hello@tala.co.uk

Instagram: @tala | Facebook: talaHQ | Pinterest: TalaLED | Tag: lighttoliveby

Tala North America, Inc. 2 Research Place, Suite 300, Rockville, MD 20850