MR6000 Viewer Instruction Manual
1. Introduction
The MR6000 Viewer is a PC application designed for viewing and analyzing measurement data recorded by the MR6000 Memory HiCorder on a personal computer.
| Supported Instruments | Product Name |
|---|---|
| MR6000, MR6000-01 | Memory HiCorder |
MR6000 Viewer Functions:
- Display measured waveforms
- Search waveforms
- Perform numerical calculation, waveform calculation, and FFT calculation
- Convert measurement data to CSV format
2. System Requirements
To use the MR6000 Viewer, the following minimum computer system configuration is required:
| Category | Requirement |
|---|---|
| OS | Windows® 10 64-bit version
How to check your system's version:
|
| Memory | Minimum 8GB |
| Display | Resolution of 1280×1024 or better |
| Installation account | Administrator |
| Execution account | Administrator |
Note:
- MR6000 Viewer does not support the 32-bit version of Windows 10.
- Certain PC environments may not support full operation of the MR6000 Viewer despite meeting the minimum requirements.
3. Setup
To install the software MR6000 Viewer, refer to the MR6000 Viewer Installation Procedures.
4. Using the Software
Perform the following steps using an administrator account.
4.1. Launching the Application
From the [Start] menu, select [HIOKI] - [MR6000 Viewer] to launch the application.
[Illustration shows the Windows Start menu with HIOKI and MR6000 Viewer highlighted.]
4.2. Loading Measurement Data
Use either of the following methods to load a waveform onto the application:
- Click the ? (Folder Icon) to open the file selection screen.
- Select the storage media and folder containing the desired file, then double-click the file to load it.
Alternatively, drag and drop the waveform data file onto the application screen.
[Illustration shows a file explorer window for selecting a .MEM file and a waveform display area where a file can be dropped.]
4.3. Saving Data
Click the ? (Save Icon) to save any of the following:
- Waveform data
- Screen shot
- Numerical calculation results
- Settings
Procedures:
- Click the ? (Save Icon).
- Click [Folder:] to select the target directory to save the file. Edit the [Type] or [Channel] as required.
- Click [Execute] to proceed.
[Illustration shows the Save dialog box with fields for Folder, File name, Type, Channel, etc., and buttons for Execute and Cancel.]
Note: The MR6000 Viewer operates differently from the MR6000 Memory HiCorder. A [HIOKI_MR6000] folder will not be automatically created. Please save your data directly into the appropriate folder.
4.4. Zoom In and Zoom Out Waveforms
To zoom in and out with respect to the time axis, move your mouse over the area below the waveform and rotate the center wheel of the mouse. You can also zoom by positioning the mouse arrow on any part of the waveform and pressing the [Ctrl] key while rotating the center wheel.
[Illustration shows a waveform with a horizontal yellow arrow indicating zoom on the time axis.]
To zoom in and out with respect to the waveform's vertical axis, move your mouse over the area to the left of the waveform and rotate the center wheel of the mouse. You can also zoom by positioning the mouse arrow on any part of the waveform and pressing the [Shift] key while rotating the center wheel.
[Illustration shows a waveform with a vertical yellow arrow indicating zoom on the vertical axis.]
4.5. Quitting the Application
Click the ❌ (Close Button) on the top right corner of the application window to quit the application.
