Remington R3010/R3011 Rechargeable Cordless Rotary Shaver

Important Safety Instructions

When using an electrical appliance, basic precautions should always be observed, including the following:

READ ALL INSTRUCTIONS BEFORE USING THIS APPLIANCE.

DANGER

To reduce the risk of fire or electric shock, follow these instructions carefully:

• For connection of the power supply unit to a power source not in the U.S.A. and Canada, use a USB cable of the proper configuration for the power outlet.
• Do not reach for a plugged-in appliance that has fallen into water. Unplug it immediately.
• Do not use while bathing or in the shower.
• The shaver can only be used in dry conditions. Do not rinse under the faucet to clean.
• Detach the appliance from the power supply cord before cleaning.
• Do not submerge in water.
• Do not place or store this appliance where it can fall or be pulled into a tub or sink. Do not place or drop into water or other liquid.
• Except when charging, always unplug this appliance from the electrical outlet immediately after using.
• Unplug this appliance before cleaning.

WARNING

To reduce the risk of burns, fire, electric shock or injury to persons:

• An appliance should never be left unattended when it's plugged in, except when charging a rechargeable appliance.
• Close supervision is necessary when this appliance is used by, on, or near children, or individuals with certain disabilities or special needs.
• Children should be supervised to ensure that they do not play with the appliance.
• Use this appliance only for its intended use as described in this manual. Do not use attachments not recommended by the manufacturer.
• Never operate this appliance if it has a damaged cord or plug or if it is not working properly, if it has been dropped or damaged, or if it has been dropped into water.
• Keep the cord away from heated surfaces.
• Never drop or insert any object into any of the appliance's openings.
• Household use only.
• Do not use outdoors or operate where aerosol (spray) products are being used or where oxygen is being administered.
• Always attach the plug to the appliance, then to outlet. To disconnect, turn all controls to OFF, then remove plug from outlet.
• Always pull on cord plug to unplug from wall socket. Never pull on electric cord.
• Do not plug or unplug this appliance when your hands are wet.
• Do not use an extension cord or a voltage converter with this appliance.
• Do not wrap the cord around the appliance.
• Always store this appliance and cord in a moisture-free area. Do not store it in temperatures exceeding 140°F (60°C).
• Detach removable power cords from appliance for storage.
• Do not use this appliance with a damaged or broken head or cutters, as facial injury may occur.
• The power unit is intended to be correctly oriented in a vertical or floor mount position.
• Shavers, including the trimmer, are for use on facial hair only. They should not be used for shaving the hair on your head or any other part of your body.

SAVE THESE INSTRUCTIONS

Product Features

Charging

Before using, read the important safety instructions in front of the manual.

1. Plug USB charging cable into shaver (A).
2. Plug USB charging cable into any standard USB Type-A wall adaptor.
3. Leave adaptor plugged in for 10 hours to fully charge shaver. Then unplug shaver and adaptor.
4. Use shaver until recharge is required.

Note: Recharging after every use will shorten the battery life.

CAUTION!

• Make sure the shaver and your hands are dry when charging the shaver.
• Always charge the shaver in a cool, dry place.

Shaving

1. Slide up On/Off slide switch to turn on (B).
2. Shave face and neck using short, circular strokes (C).

Shaving Tips

• Wait at least 15 minutes after getting up before shaving, to ensure your face is free of puffiness that may be present from sleeping.
• Ensure your skin is dry and free of oils. Try using Remington's FaceSaver pre-shave powder to help the shaver glide across the skin.
• Always hold the shaver at a right angle to the skin so that all three heads are touching the skin with equal pressure.
• Stretch skin with the free hand so hairs stand upright, making it easier for them to enter the cutting chamber.
• Use moderate to slow circular stroking movement.
• The use of short circular motions in stubborn areas may obtain a closer shave, especially along the neck and chin line.
• Do not press hard against the skin in order to avoid increased irritation and damage to the rotary heads.

We recommend that you use your new shaver daily for up to four weeks to allow time for your hair and skin to become accustomed to the new shaving system.

Stubble and Trim

Stubble Attachment

To achieve a stubble look instead of a clean shave, affix the Stubble attachment/Head guard over the cutter assembly and shave as usual.

Trim

1. Press trimmer release button to engage trimmer (D).
2. Trim long, difficult hairs and side burns (E).
3. Close trimmer by pressing down until it snaps closed (F).

Cleaning and Care

NOTE: When cleaning your shaver, make sure the shaver is turned off and disconnected from the power cord.

CAUTION!

• To clean the external surfaces of the shaver, use a damp cloth. Do not use strong detergents or other chemicals.
• To dry, wipe the surface of the shaver with a dry towel. Do not use a hair dryer or heater to dry the shaver.

Daily Cleaning

1. Pull off Stubble comb/Head guard, if using, and rinse attachment.
2. Press the release button on front of shaver and open head assembly (H).
3. Tap out the collected hair shavings and use the included cleaning brush to brush the rest out (I).
4. Snap head closed before using the shaver again (J).
5. Reattach the Stubble comb/Head guard to protect the shaving head until next use.

Weekly Cleaning

1. Perform the daily cleaning steps 1 and 2.
2. Remove the cover from the hair pocket assembly (K). Place the body of the shaver aside to ensure that it will not get wet.
3. Slide the blue inner cutter carrier down to release it from the assembly (L).
4. Remove the inner cutter carrier away from the cutters.
5. Remove the cutters (M).
6. Thoroughly rinse away any debris from inner and outer cutters (N).
7. Replace the inner cutters. Match the hub colors of the inner and outer cutters (O).
8. Place the inner cutter carrier back into position and lock into place (P).
9. Lubricate each cutter with household oil.
10. Align the spring hinge into the slot at the back of the hair pocket and press into place. Snap the head assembly closed (J).

Trimmer: Lubricate teeth with oil every six months.

Product Disposal

When your rechargeable shaver reaches the end of its useful life, the rechargeable batteries must be removed from the shaver and be recycled or disposed of properly in accordance with your state and local requirements. If this is not required by law, you may elect to dispose of the shaver with the batteries.

To Remove the Rechargeable Battery:

1. Run shaver until the motor stops.
2. Unscrew the 2 screws on rear housing (one is located under the trimmer).
3. Pry off the rear housing and expose the battery.
4. Lift the battery carrier and circuit board out of the shaver body and then cut the tabs holding the batteries to the circuit board.
5. Dispose of batteries safely.

This device uses one of the following types of rechargeable batteries: nickel metal hydride (NiMH), nickel cadmium (Ni-Cd) or Lithium Ion (Li-Ion) (see included battery for indication of type).

CAUTION: ALL RECHARGEABLE BATTERIES MUST BE RECYCLED OR DISPOSED OF IN ACCORDANCE WITH APPLICABLE STATE AND LOCAL REGULATIONS. DO NOT PUT IN FIRE OR MUTILATE, AS THE BATTERY MAY BURST OR RELEASE TOXIC MATERIALS. DO NOT SHORT-CIRCUIT, AS THIS MAY CAUSE BURNS.

Please do not throw this product away with normal household waste. If possible, take it to an official collection point in your area that recycles this type of product. Thank you for considering the environment.

Warranty Information

Warranty details are provided in a separate insert.

This warranty shall not be valid where it is contrary to U.S. and other applicable laws, or where the warranty would be prohibited under any economic sanctions, export control laws, embargos, or other restrictive trade measures enforced by the United States or other applicable jurisdictions. This includes, without limitation, any warranty claims implicating parties from, or otherwise located in, Cuba, Iran, North Korea, Syria and the disputed Crimea region.

Product Details

Input: 5V dc

Type: R31B

Questions or comments: Visit remingtonlatam.com

Distributed by: Empower Brands, LLC, Middleton, WI 53562

® Registered trademark and ™ trademark of Empower Brands, LLC

© 2024 Empower Brands, LLC. All rights reserved.

Made in China.