Remington R3000AU Comfort Precision Rotary Shaver

Important Safety Instructions

When using electrical appliances, basic precautions should always be observed, including the following.

READ ALL INSTRUCTIONS BEFORE USING

DANGER: As with most electrical appliances, electrical parts are electrically live even when the switch is off.

For additional protection, the installation of a residual current device (rcd) having a rated residual operating current not exceeding 30 mA is advisable in the electrical circuit supplying the bathroom. Ask your installer for advice.

WARNING: TO REDUCE THE RISK OF BURNS, ELECTROCUTION AND FIRE OR INJURY TO PERSONS

• The appliance should never be left unattended when plugged into a power outlet, except when charging the appliance.
• This appliance should not be used by children or other persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge unless they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved.
• Children shall not play with the appliance.
• Cleaning and user maintenance shall not be made by children without supervision.
• Never operate this appliance if it has a damaged cord or plug, if it is not working correctly, if it has been dropped or damaged, or dropped into water. If the supply cord or plug of the appliance is damaged it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard. It cannot be repaired.
• Keep the cord away from heated surfaces.
• Charge, use and store the product at a temperature between 0°C and 32°C.
• Do not use outdoors or where aerosol (spray) products are being used, or where oxygen is being administered.
• Do not use this appliance with damaged or broken tracks, foils or cutters, as injury may occur.
• For use on facial hair only. Not intended for shaving the hair on your head.
• Do not plug or unplug the appliance with wet hands.
• For household use only.
• Do not place or store the appliance or charging adaptor where it can fall or be knocked into a sink or bath.
• Do not place in or drop into water or any other liquid.
• If an appliance falls into water, “unplug it” immediately. Do not reach into the water.
• Unplug the charging adaptor from the electrical outlet immediately after fully charging.
• Use this appliance only for its intended use as described in this manual.
• Do not use attachments not recommended by Remington.
• Never drop or insert any object into any opening of this appliance.
• Always store the charging adaptor in a moisture-free location.
• Do not use on people who are asleep.
• Do not use an extension cord or a voltage converter with this appliance.
• Do not wrap the cord around the appliance.
• Remington strongly recommends that an approved Safety Switch (Residual current device) be installed to protect all bathroom power outlets. Ask an electrical contractor for advice.

SAVE THESE INSTRUCTIONS

Product Overview

Thank you for purchasing your new Remington® Comfort Precision rotary shaver. Inside this manual you will find tips on using and caring for your shaver.

Key Parts

• 1. On/Off Button
• 2. Shaving Head
• 3. Head Release Button
• 4. Pop Up Trimmer (not shown)
• 5. Power Port (not shown)
• Also Includes: Head Guard, Cleaning Brush, Power Adaptor

Specifications

Voltage Type: Worldwide Voltage – shaver automatically adapts to an outlet voltage between 100V and 240V.

Note: Some countries will require the use of a plug adaptor that is not included with your shaver.

Charging

Before using, read the important safety instructions in this manual.

Diagram A: Connect the shaver to the adaptor.

Diagram B: Connect to the mains.

Diagram C: Charge for 16 hours.

1. Ensure the product is switched off. Connect the shaver to the adaptor (Diagram A).
2. Connect to the mains (Diagram B) and charge for 16 hours when using for the first time (Diagram C). This first charge is important to the shaver's battery life.
3. When empty, the battery should be charged for 16 hours, and will provide 40 minutes of shaving time.
4. Do not shave in the shower. The shaver is not waterproof. The easy to clean head pops open to rinse under the water.

Caution:

• Make sure the shaver and your hands are dry when charging the shaver.
• Always charge the shaver in a cool, dry place.

Shaving

Diagram D: Power button.

Diagram E: Shaving face and neck.

1. Press power button to turn on. (Diagram D)
2. Shave face and neck using short, circular strokes. (Diagram E)
3. After shaving, turn the shaver off. (Diagram D)

Shaving Tips

• Wait at least 15 minutes after getting up before shaving, to ensure your face is free of puffiness that may be present from sleeping.
• Always hold the shaver at a right angle to the skin so that all three heads are touching the skin with equal pressure.
• Stretch skin with the free hand so hairs stand upright, making it easier for them to enter the cutting chamber.
• Use moderate to slow, circular stroking movement.
• The use of short, circular motions in stubborn areas may obtain a closer shave, especially along the neck and chin line.
• Do not press hard against the skin to avoid skin irritation and/or damage to the rotary heads.
• As with every shaver, your shave will improve over time. Allow up to four weeks of daily shaving to develop an effective shaving style and for your skin to adjust to the new shaver. The adaptation period might take a little longer if your skin is sensitive, if you are switching from a different method of shaving, or if you alternate between shaving methods.

Trimming

Diagram F: Engaging the pop-up trimmer.

Diagram G: Closing the pop-up trimmer.

Pop-up Trimmer:

1. Push trimmer release button to engage trimmer. (Diagram F)
2. Trim long, difficult hairs and side burns.
3. Close trimmer by pressing down. (Diagram G)

Note: Lubricate teeth with oil every 6 months.

Cleaning & Maintenance

Daily Cleaning:

1. Open the shaver head by pressing the release button on the front of the shaver (Fig. H) and flipping open the head away from the body of the shaver (Fig. I).
2. Tap out excess hair shavings.
3. Rinse the head of the shaver in running water.
4. Close the head assembly.

Monthly Cleaning:

• Perform cleaning steps 1 and 2.
• Hold the shaver upside down so that the open cutter assembly is facing towards you. Slide the coloured cutter support frame upwards towards the shaver to release it from the assembly (Fig. J).
• Remove the cover from the hair pocket assembly. Place the body of the shaver aside to ensure that it will not get wet.
• Pull the cutter support frame away from the inner cutters (Fig. K).
• Thoroughly brush hairs from the inner and outer cutters. Rinse out remaining debris (Fig. L).
• Place the cutter support frame back into position and lock into place (Fig. M-N).
• Align the spring hinge into the slot at the back.
• Close the head assembly.

Warning:

• Only the detachable shaving head can be rinsed with water.
• DO NOT rinse the hand-held shaver under water as damage will occur.

Caution:

• Shaver heads can be rinsed with water. The water temperature should not exceed 70 degrees. Unplug the shaver and remove the head before rinsing the washable head under water.
• Keep the adaptor, shaver and cable dry.

Replacing the Head & Cutters

Please refer to the specifications' table on page 5 of this manual that lists the correct replacement part number for your shaver.

It is very important to replace your head and cutters when necessary to ensure a close, comfortable shave without irritation. Remington recommends they be replaced every 12 months. Signs of head and cutter wear include:

• Irritation: As the heads get excessively worn, you may experience some skin irritation. This would be especially noticeable when you apply moisturizing lotion.
• Pulling: When the cutters wear, you may feel a sense of pulling and a loss of closeness when you shave. This is an indication that it is time to replace your heads and cutters.

Replacement heads & cutters may be obtained directly from Remington®. Your order can be processed over the phone via the Remington® Service Hotline.

Battery Disposal

Note: The battery is not intended to be removed or replaced under normal use. The only time the battery should be removed or the unit opened or disassembled, is at the end of the product's useful life before it is discarded.

• The R3000AU contains a nickel metal hydride battery. Once the shaver has reached the end of its life, to ensure proper disposal of the product, please take the appliance to a recycling centre, where the internal rechargeable battery should be removed by a professional and recycled separately.
• For more information about recycling of electrical and battery operated appliances, please contact your local council office or your household waste disposal service.

Caution: Do not put in the fire or mutilate your batteries when disposing as they may burst and release toxic materials. Do not short circuit as it may cause burns.

Remington suggests using local waste management centres to recycle this product at end of life.

This product is not suitable for use in a bath or shower.

This product conforms to radio frequency interference requirements.

Any product purchased and used commercially carries a limited 90 Day Warranty.

Warranty Against Defects

Spectrum Brands Australia Pty Ltd and Spectrum Brands New Zealand Limited provide this warranty.

In this warranty:

• Australian Consumer Law means the Australian consumer law set out in Schedule 2 to the Competition and Consumer Act 2010.
• CGA means the New Zealand Consumer Guarantees Act 1993.
• Goods means the product or equipment which was accompanied by this warranty and purchased in Australia or New Zealand, as the case may be.
• Manufacturer, We or us means:
1. for Goods purchased in Australia, Spectrum Brands Australia Pty Ltd ACN, 007 070 573; or
2. for Goods purchased in New Zealand, Spectrum Brands New Zealand Limited, as the case may be, contact details as set out at the end of this warranty.
• Supplier means the authorised distributor or retailer of the Goods that sold you the Goods in Australia or in New Zealand.
• You means you, the original end-user purchaser of the Goods.

1. Remington's goods come with guarantees that cannot be excluded under the Australian Consumer Law, or the CGA. You are entitled to a replacement or refund for a major failure and compensation for any other reasonably foreseeable loss or damage. You are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount to a major failure.

2. The benefits provided by this Warranty are in addition to all other rights and remedies in respect of the Goods which the consumer has under either the Australian Consumer Law or the CGA. The original purchaser of the Goods is provided with the following Warranty subject to the Warranty Conditions.

3. Remington warrants the Goods for all parts defective in workmanship or materials for the period of two (2) years from the date of purchase (Warranty Period). If the Goods prove defective within the Warranty Period by reason of improper workmanship or material, Remington may, at its own discretion, repair or replace the Goods without charge.

Warranty Conditions

1. The Goods must be used in accordance with the manufacturer's instructions. This Warranty does not apply should the defect in or failure of the Goods be attributable to misuse, abuse, accident or non-observance of manufacturer's instructions on the part of the user. As far as the law permits, the manufacturer does not accept liability for any direct or consequential loss, damage or other expense caused by or arising out of any failure to use the Goods in accordance with the manufacturer's instructions.
2. Consumable parts (such as shaver heads, cutters and foils) of the Goods are included under this Warranty only where there is a defect in workmanship or materials used.
3. The warranty granted under clause 3 is limited to repair or replacement only.
4. Any parts of the Goods replaced during repairs or any product replaced remain the property of the manufacturer. In the event of the Goods being replaced during the Warranty Period, the warranty on the replacement Goods will expire on the same date as for the Warranty Period on the original Goods which are replaced.
5. In order to claim under the warranty granted under clause 3 you must:
   • (a) Retain this warranty with your receipt/proof of purchase; and
   • (b) Return the Goods to Remington at the relevant address below or to the Supplier by prepaid freight within the Warranty Period accompanied with (i) the legible and unmodified original proof of purchase, which clearly indicates the name and address of the Supplier, the date and place of purchase, the product name or other product serial number and (ii) this warranty.
6. This warranty is immediately void if:
   • (a) Any serial number or appliance plate is removed or defaced;
   • (b) The Goods have been serviced or otherwise repaired by a person not authorised to do so by Remington or where non approved replaced parts are used.
7. The Goods are designed for domestic use only. A limited 90-day Warranty applies to any industrial or commercial use of the Goods. The Goods must be connected to the electrical voltage requirements as specified in the ratings label located on the Goods.
8. This warranty does not cover the cost of claiming under the warranty or transport of the Goods to and from the Supplier or Remington.
9. This warranty is only valid and enforceable in Australia against Spectrum Brands Australia Pty Ltd and in New Zealand against Spectrum Brands New Zealand Limited.

Contact Remington or the Supplier for further details.

Spectrum Brands Australia Pty Ltd
Locked Bag 3004
Braeside, VIC 3195
AUSTRALIA
Customer service in Australia: 1800 623 118
E-mail: consumer.enquiry@remington-products.com.au
Website: www.remington-products.com.au

Spectrum Brands New Zealand Limited
PO Box 9817
Newmarket, Auckland 1149
NEW ZEALAND
Customer service in New Zealand: 0800 736 776
E-mail: info@remington.co.nz
Website: www.remington.co.nz

Remington Service Hotline

• Australia: 1800 623 118 (toll free)
• New Zealand: 0800 736 776 (toll free)

Authorised Repair Centres

Visit www.remington-products.com.au for Authorised repair centre details.

Registered Trade Mark of Spectrum Brands Inc., (SBI) or one of its subsidiaries.
© 2022 Spectrum Brands Inc.
Rev. 05/22
Part No. T22-7000869
Type: R07A

Please recycle.