Mercedes-Benz Unimog U5023

General Information and Warnings

JAMARA e.K. is not liable for any damage caused to the product itself or through this, provided this is due to improper operation or handling errors. The Customer alone bears the full responsibility for the proper use and handling, including without limitation, the assembly, the charging process, the use and choice of the operation area. Please refer to the operating and user instructions, it contains important information and warnings.

Age Recommendation: Suitable for children over 6 years.

Warning: Not suitable for children under 36 months. RISK OF SUFFOCATION! Contains small parts which can be swallowed. Keep away necessarily from children.

This device is not intended for use by individuals (including children) with reduced physical, sensory, or mental abilities, or lack of experience and/or knowledge, unless they are supervised by a person responsible for their safety regarding how the device is to be used.

Safety Instructions & Precautions

Please read the complete instructions and security instructions carefully before using the model. Caution! Please fully and carefully read warnings/safety instructions. These are for your own security and can avoid accidents/injuries.

General Safety Notes:

• Keep hands away from moving parts.
• Use only under direct supervision of an adult.
• If batteries are empty, replace them.
• Pay attention to polarity!
• Do not operate in rain, snow, wetness, or sand.
• Never drive on roads or areas used by real vehicles.
• Never run out of the reach of your remote control.
• Do not expose to direct sunlight or heat.
• Clean with a damp cloth.
• Store batteries/battery packs separately when not in use.

Declaration of Conformity

JAMARA e.K. declares that the product "Mercedes-Benz Unimog U5023, No. 408310" complies with Directive 2014/53/EU, 2011/65/EU, 2009/48/EC and the regulation (EU) 2023/1542. The full text of the EU Declaration of Conformity is available at: www.jamara-shop.com/Conformity

Operating Instructions

Before Operation:

• Always switch the model on first, then the transmitter.
• When operating multiple models simultaneously, switch on one model and its corresponding transmitter at a time. Do not switch on multiple models or transmitters at the same time to avoid interference.

When Finished:

• First switch off the model, then the transmitter.
• Never operate the model beyond your line of sight. Range depends on factors like weather and interference. Perform a range test before each use with a second person to check signal failure behavior.

Binding Process:

Insert batteries into the transmitter (LED flashes). Switch on the model (headlights flash). Successful binding is indicated by the transmitter LED stopping flashing, a short beep, and the model's headlights staying on continuously. Bind one model at a time.

Transmitter Controls:

Diagram Description: The transmitter features a steering wheel, throttle stick, various switches and buttons, and a battery compartment.

• 1. Beginner / Professional Mode: Adjust this lever to increase or decrease the vehicle's maximum speed.
• 2. Steering Trim: Used to fine-tune the steering to ensure the model drives straight when no command is given.
• 3. Lights On/Off: Slide the control to switch the lights on or off.
• 4. Hazard Warning Lights: Turn the steering wheel right for 3 seconds to activate; turn left for 3 seconds to deactivate.
• 5. Forward / Reverse | Left / Right:
  • a. Forward / Reverse: Push the throttle stick backward or forward to drive the model forward or backward.
  • b. Left / Right Turn: Use the steering wheel to control the direction. Turning the wheel left or right steers the model accordingly.
• 6. Engine Off / Auto Shutdown: If the model receives no input for approximately 10 minutes, it will automatically shut down and must be restarted.
• 7. Steering Reverse Switch: Electronically switches the direction of the steering servo travel.

Battery Handling

Charging the Battery:

1. Remove the battery from the model.
2. Connect the battery to the USB charging cable. Insert the USB plug into your computer's USB port. The LED will flash during charging and remain solid when charging is complete (approx. 3-4 hours).
3. Connect the charged battery pack (observe polarity: red +, black -) and place it in the battery compartment. Close the cover.

Battery Warnings:

• Non-rechargeable batteries are not to be recharged.
• Do not open, dispose of in fire, mix old and new batteries, or mix battery types (alkaline, carbon-zinc, rechargeable).
• Rechargeable batteries must be removed from the model before charging and charged only under adult supervision.
• Do not short-circuit the supply terminals.

Cooling and Storage:

• Allow the model to cool down sufficiently after each use before operating again. Allow at least 10 minutes for cooling, especially when changing batteries. Overheating can damage electronics or cause fire.
• Always disconnect the battery from the charger and the charger from the power supply immediately after charging. Leaving them connected can cause damage or fire hazard.
• If the model has an on/off switch, turn it off immediately after use. If it has a removable battery, disconnect it. Leaving the model or battery connected can lead to deep discharge, damage, or self-ignition.
• Never attempt to charge or discharge deeply discharged batteries. Battery voltage should not drop below 6V. A fully charged battery is approx. 8.4V.
• Intact batteries should be fully charged after a cooling phase (min. 10 min, max. 12 hrs) to prevent self-discharge.
• Store batteries separately and check voltage (min. 8V) or damage at least every 3 months; recharge or dispose of as necessary.

Parts List

Maintenance and Care

This product is a model building article and requires regular maintenance. Check for damage, screw connections, and clean regularly. Wear parts like gears and pinions will wear out over time and need replacement. Crash damage must also be repaired or replaced. Wear parts or parts damaged due to crashes or insufficient maintenance are not covered by warranty; costs and repairs are the buyer's responsibility.

Disposal Information

Batteries and accumulators must not be disposed of in domestic waste but must be disposed of separately. Return used batteries to collection points or retail stores. Batteries contain substances that can be irritant, cause allergies, or are highly reactive; proper collection and recycling are important for the environment and health. If batteries are marked with Hg, Cd, or Pb, they contain more than 0.0005% mercury, 0.002% cadmium, or 0.004% lead, respectively.

Electrical appliances must not be disposed of in domestic waste and must be disposed of separately. Remove batteries if possible and take the electrical equipment to communal collection points. Remove any personal data from the appliance yourself.

Service Information

Contact details for service centers and distributors are provided for various regions.

JAMARA e.K.
Am Lauerbühl 5
DE-88317 Aichstetten
Tel: +49 (0) 7565 9412-0
Email: info@jamara.com
Website: www.jamara.com