Bromic Refrigeration Instruction Manual: Deli Displays

1. Prefix

This manual contains important information regarding the installation, operation, and maintenance of Bromic Deli Display units. Please pay close attention to the safety information provided, which will be accompanied by the following alert symbols:

DANGER, WARNING, IMPORTANT

• READ THIS MANUAL CAREFULLY before installing or servicing this product.
• Improper installation, operation, or maintenance can result in death, severe injury, or property damage.
• Improper installation, operation, or maintenance may also result in warranty being voided.
• This appliance is intended for 230-240 Volt power supply.
• Installation MUST be carried out by a licensed and authorised technician in accordance with local electrical codes.
• Installation and maintenance MUST be carried out as per instruction, by a qualified technician in accordance with local regulation.

2. Important Notes & Warnings

• Read all instructions before installing or using this appliance.
• Retain this manual for future reference.
• Use this appliance only as described in this manual. Any other use not recommended by the manufacturer may cause fire, electric shock or injury.
• Improper installation, adjustment or alteration and failure to follow the warnings and instructions in this manual could result in severe personal injury, death or property damage.
• The manufacturer is not responsible for any damage that could happen from improper use. The manufacturer emphasises that this appliance should be used in a responsible manner and that all procedures, warnings, and safety instructions contained in this booklet be followed strictly.
• Check the appliance for damage. Do not operate a damaged unit.
• Check for damage to the appliance regularly. If damage to the appliance is suspected, discontinue use immediately and contact the supplier or qualified person to repair.
• This appliance is not intended for use by people (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible of their safety.
• Keep packaging material out reach of children.
• Children should be carefully supervised to ensure that they do not play with the appliance.
• Do not attempt to alter the appliance in any manner.
• Pay attention to the maximum load limit when filling the shelves.
• All work on electrical equipment must be carried out by a qualified and licensed technician only.
• Do not perform maintenance until the appliance has been turned off and power disconnected.
• Never detach any cover except where specifically instructed in this manual. Doing so might expose live electrical parts.
• Do not operate the appliance with panels, covers or guards removed.
• Keep the air intake and outlets free of obstructions.
• Do not use the appliance outdoors.
• If the supply cord becomes damaged, it must be replaced by an authorised service agent or similarly qualified person in order to avoid a hazard.
• If the appliance has not been used, or will not be used for a long period of time, disconnect power supply.
• The appliance must be installed in accordance to AS1677.2:1998 to ensure there are no sources of ignition in any area where refrigerant could gather in the event of a leak.
• Electrical equipment should not be placed under the unit or where refrigerant could gather in the event of a leak.
• Installation/servicing of the appliance must be performed by a licensed technician with Gas Work Authorization if the appliance gas system is being opened or charged.
• The refrigerant used in all appliances covered by this manual are flammable.

Caution: Risk of fire ⚠️

3. Packaging and Handling

• This Deli display contains fragile glass. The unit must always be handled with care.
• Adjust the width of forklift tines such that they line up with the structural supports on the Deli unit before lifting.
• The Deli unit must always be handled on flat and level ground.
• Take care not to damage the castors, while inserting forklift tines into the pallet.

Visual Description: Diagram showing a forklift carefully lifting a deli display unit, with other diagrams illustrating correct and incorrect ways to handle the unit with a forklift, emphasizing alignment with structural supports and avoiding damage to castors.

4. Product Overview

Specifications for Bromic Deli Displays:

*Door swing dimensions are given as the size of the entire cabinet when the specified doors are opened such that the cabinet produces the largest possible footprint.

5. Installation

Locating the Cabinet

Ensure the following instructions are observed for proper and trouble-free operation:

• Do not install the cabinet outdoors.
• Locate the appliance in a dry and well-ventilated place.
• The unit must be positioned on a level surface.
• Do not install in the vicinity of heating radiators or other heat sources.
• Do not install the appliance where it is exposed to direct sunlight.
• Do not install the appliance where it is exposed to warm draughts or open doors.
• Keep the air intake and outlets free of obstructions.
• Adequate allowance should be made for door openings.

Visual Description: Diagrams illustrating ventilation requirements, showing airflow around the unit and indicating required clearances.

Ventilation

• Allow 150mm clearance between walls and the appliance.
• Ensure that the condenser fan is free to take in ambient air from the room.
• Adherence to minimum clearances is necessary.

NOTE: The maximum ambient temperature for the refrigerator is 30°C. Conditions outside this temperature will result in cabinet temperatures outside the required 2 to 8°C range. Bromic recommends that the refrigerator is installed at an ambient temperature of 20 to 25°C.

Power Supply

• The appliance must not be plugged into a multiple outlet power board.
• The appliance is supplied with a flexible power cord fitted with a 3-pin plug.
• The socket used must be properly earthed and fuse/RCD protected.
• See the rating label inside the cabinet for supply voltage, frequency and current draw.
• Power cable is rated 70°C. It is recommended that the cable should not come into contact with parts over 50°C.
• Do not turn off power before consulting the person responsible.
• Mark the power source clearly, so the refrigerator is not unplugged or turned off accidentally.

Visual Description: Image of a standard 3-pin plug and socket, contrasted with an image of a power strip with a red cross over it, indicating it should not be used.

Before Operating

• If the appliance has been sharply tilted or transported in the horizontal position, it must be left to stand in the upright position and not plugged in for at least 4 hours.
• Remove all the packaging material before using the appliance.
• Start the appliance only if it has been installed as described.

6. Operation

Start-up

• Connect the appliance to the mains power supply.
• The switches control cabinet cooling, defrost, and lights respectively. Flip all switches on for cabinet operation.
• The compressor and condenser fan should operate within 3 minutes after the Refrigeration switch is turned on.
• The electronic controller will display the current cabinet temperature after the Refrigeration switch is turned on.
• The [LED indicator] indicates that the refrigeration circuit is operating.
• During the start-up delay (3 minutes), the [LED indicator] is flashing.
• The [LED indicator] indicates that the refrigeration circuit is defrosting.

Visual Description: Images of the control panel switches and the electronic temperature controller display. The controller shows a temperature of 3.8°C, with icons for various functions like cooling, defrost, eco mode, and fan speed. The temperature is set using 'SET', '▲', and '▼' buttons.

Setting the temperature

1. Press the SET button for more than 3 seconds.
2. The value of the set point will be displayed and the '°C' or '°F' LED starts blinking.
3. Press ▲ or ▼ arrow key within 10 seconds to adjust the set point.
4. Press the SET key again or wait 10 seconds.

7. Product Loading and Storage

IMPORTANT: Run the refrigerator for at least 2 hours before loading.

WARNING: Do not store explosive substances such as aerosol cans with a flammable propellant inside the appliance.

Start-up

• Clean the interior surface with a soft cloth and warm water before loading.
• Ensure there is free circulation of air between the products.
• Do not block the evaporator fan.
• Do not overstock the refrigerator.
• Keep refrigerator door openings to a minimum.
• Some products are sensitive to ultraviolet (UV) light; please see storage guidelines from the manufacturer before removing from packaging.
• Do not block the rear or front grill when loading the Deli. This can reduce cooling performance.
• Do not overload the cabinet. Loading limit height is 150mm from the base of the cabinet. Bromic cannot guarantee that goods loaded above the 150mm limit will remain within the food-safe temperature range.

NOTE: Bromic cannot be responsible for loss of stock or damage to stock.

8. Maintenance

IMPORTANT: Repairs on the unit must be carried out by an authorised and licensed person only. Contact the manufacturer or an approved service agent for any repairs needed.

WARNING: Disconnect the appliance from the power supply before performing any maintenance. Never unplug the appliance by pulling on the cord. Always grasp the plug firmly and pull straight out of the outlet.

WARNING: Exposure to significant water ingress will void warranty and cause potential safety issues. If the unit should be exposed to water, please contact the manufacturer immediately.

IMPORTANT: Warranty may be void if there is no evidence of preventative maintenance is performed on the appliance.

Cleaning the Cabinet

• Remove the products and transfer to a suitable location prior to cleaning the inside of the cabinet.
• Do not use any aggressive or abrasive cleaning agents.
• Never use a water hose or a high-pressure jet to clean.
• Do not use sharp or pointed objects for cleaning.
• Clean the inside and outside of the appliance with a clean damp cloth or with a neutral cleanser.
• Dry all surfaces with a dry cloth.

Condenser Coil/Filter

IMPORTANT: The filter and the condenser coil must be cleaned once a month. The filter can be removed for cleaning with water; make sure it is dried before reattaching. The condenser coil must be cleaned with vacuum/brush monthly to maintain the performance and minimise power consumption. A poorly maintained condenser coil can lead to failure of the unit and higher cabinet temperatures.

General cleaning

• The Deli display must be wiped down regularly.
• Preventing the build-up of oil and sediments will increase the longevity of the unit.

Condenser cleaning

• The Deli's front panel must be removed to properly clean the condenser.
• A clogged condenser can result in reduced cooling performance.
• The condenser must be cleaned every 6 weeks.
• Recommended cleaning methods include:
• Vacuum cleaner
• Cleaning brush
• Compressed air

Drain hose cleaning

• The drainage hose must be kept clean and clear.
• The drainage hose can be cleaned via the quick-access panel.
• A blocked condensate hose can result in reduced cooling performance.

Visual Description: Image showing the condenser unit inside the display, and another image showing the location of the drain hose access panel.

9. Troubleshooting

IMPORTANT: Repairs on the unit must be carried out by an authorised and licensed person only. Contact the manufacturer or an approved service agent for any repairs needed.

10. Multiplexing Procedure

The multiplexing procedure can be used to connect multiple Bromic Deli units together.

• A Bromic multiplexing kit must be used for this procedure.
• The multiplexing procedure must be performed by a licensed technician.

Visual Description: Diagrams illustrating the components of a side cover kit and a multiplexing kit, with numbered parts and their corresponding descriptions and quantities.

11. Accessories List

Bromic offers the following additional accessories for the Deli Display Fridges. Accessories can be ordered through your local Bromic sales representative.

• Knife Holder
• Bag Holder
• Paper Holder
• Scale Deck
• Cutting Board

Installation

1. 2x bolts slide along the rail on the rear of the Deli Display. Insert them on either end of the rail.
2. The accessories are then fit onto the two bolts via two pre-drilled holes.
3. 2x wing nuts are used to hold the accessory in place.
4. The accessory can be slid back and forth along the rail.

Visual Description: Image showing how an accessory is mounted onto the rails of the deli display using bolts and wing nuts.

12. Environmental and Disposal Notes

These refrigerated cabinets are designed to high standards of environmental protection and recycling convenience. Cyclopentane, an environmentally friendly foaming agent, has been used. Cyclopentane is distinguished by zero ozone depletion potential (ODP) and zero global warming potential (GWP). The refrigerant used and contained within a hermetically tight circuit is environmentally friendly and does not contain chlorine and zero ODP.

The device must be disposed of in accordance with applicable regulations. The WEEE regulations must be observed.

In the interest of preventing environmental nuisance and promoting re-use of the high quality materials employed, used commercial refrigeration equipment must be collected for expert disposal and recycling. Therefore, observe the following disposal regulations:

• The cabinet must not be discarded with regular waste.
• The refrigeration circuit must not be damaged.
• Before disposal, make it unserviceable by disconnecting the power plug and cutting off the power cable.
• Consult your local authorities or authorised dealers for details of collection and disposal facilities.

Children are often unable to recognise the dangers associated with commercial refrigeration equipment. Proper supervision must be maintained and children must be prevented from playing with discarded refrigerated cabinets.

The refrigerant used in all appliances covered by this manual are flammable.

RISK OF FIRE ⚠️

13. Warranty

All Bromic products are manufactured to the highest quality standard and are supported by our Extra Care Service Warranty, including guarantees against any material or workmanship defects; guarantees that cannot be excluded under Australian Consumer Law.

Warranty Terms vary across the range. Please ensure you are familiar with the Terms and Conditions that apply to the purchase of your Bromic product by referring to the Warranty Policy included with your purchased product.

Alternatively, you can also download the Warranty Policy at www.bromicgroup.com/warranty-information.

How to Place a Service Request

• Please call 1300 276 642 to place a warranty service request and let the operator know whether you need Priority A or B service. More information can be found below.
• Ensure you have the serial number of your product ready before contacting us.
• The serial number of your product can be found on a compliance plate located on the inside right and at the rear of your cabinet.

Visual Description: Example of a compliance plate showing product details like Part Number, Serial Number, Model, Refrigerant Type, Voltage, Frequency, Power, etc.

Service Request Priority

PRIORITY A SERVICE: When the unit is NOT performing its primary function such as cooling or heating, or presents an OH&S or food safety risk.

PRIORITY B SERVICE: When the unit is performing its primary function, and presents no OH&S or food safety risk (e.g., lights, gaskets, locks, door adjustment).

Service Call Placement

SERVICE CALL PLACED BEFORE MIDDAY:
Priority A - Technician to attend site within 4 hours.
Priority B - Technician to attend site within 8 business hours.

SERVICE CALL PLACED AFTER MIDDAY:
Priority A - Technician attends site before midday on the following business day.
Priority B - Technician attends site before 4pm on the following business day.

Contact Information

BROMIC REFRIGERATION
10 Phiney Place, Ingleburn (Sydney)
NSW 2565 Australia
Tel: 1300 276 642
For further product information: bromicrefrigeration.com.au