Before You Begin
Ensure you have the necessary tools. A Phillips head screwdriver is required. ?
Important Safety and Assembly Tips:
- Do not assemble on a surface that can be damaged. ❌
- Two people may be needed for certain steps. ✔️
- Assemble on a soft surface like a rug to prevent scratches. ✔️
- If you encounter issues, contact IKEA for assistance. ❓ ? IKEA
Parts List
- Screw (Part No. 100408): 3x (for drawer knobs)
- Screw (Part No. 154571): 15x (for frame and leg assembly)
- Bolt (Part No. 130445): 14x (for frame and drawer runner assembly)
- Allen Key: 1x (tool)
Assembly Steps
Attach the first set of frame components. Ensure correct orientation of holes. Use 1x bolt (130445) and 2x screws (154571) as indicated. Avoid overtightening at this stage. ? ⚙️
Diagram shows correct alignment of parts with holes for screws/bolts. An incorrect assembly is shown with an 'X' symbol. ❌
Connect additional frame pieces. Align the parts carefully. Use 2x screws (154571) to secure. ?
Diagram shows connecting two frame sections. An incorrect method is shown with an 'X' symbol. ❌
Continue assembling the desk frame. Insert and secure with 4x screws (154571). ?
Diagram shows further frame assembly, similar to step 2.
Attach the assembled frame to the main tabletop base. Use 3x screws (154571) to secure the frame to the base. ?
Diagram shows the frame being attached to the flat tabletop base, with screws being inserted.
Attach the desk legs. Insert 4x screws (154571) through the frame and into the tabletop base. ?
Diagram shows attaching the legs to the underside of the tabletop base using screws.
Secure all frame connections. Use the Allen key to tighten all 10x bolts (130445) that were previously inserted. ⚙️ ↻
Diagram shows using the Allen key to tighten bolts, with a circular arrow indicating tightening motion.
Insert the drawers into their designated slots. The drawers should slide smoothly. → → →
Diagram shows the desk with drawers being slid into place.
Attach the drawer knobs. Use 3x screws (100408) to secure the knobs to the front of each drawer. ?
Diagram shows a close-up of a drawer front, with a knob being attached using a screw.
Secure drawer runners or related components. Use 3x bolts (130445). ?
Diagram shows bolts being used in relation to the drawer mechanism.
Ensure all screws and bolts are tightened. Check that the drawers open and close smoothly. ✔️
Diagram shows the completed desk with drawers. Another diagram shows the drawers being tested.
