User Manual

Introduction

Thank you for choosing our product! This fairy string light is lightweight, bendable, and waterproof. It contains addressable ICs inside the beads. Accompanied by our first-class controller, the product performs outstanding colors and magic light effects. With the APP, you can adjust its colors, brightness, preset modes, DIY modes, and music modes.

Install

1. Just unroll the string light.
2. Plug the controller into a USB adapter.
3. Then put the string light where you want.

Note: The strip light is waterproof, while the controller is NOT. Do not pull the string with much strength, otherwise it may break. For any questions or defect issues, please contact us.

Control by app

1. Download the 'DayBetter' APP and install it on your phone.
2. Turn on Bluetooth on your phone.
3. Open the APP, tap the '+' icon in the top right corner and search for a new device.
4. The APP will show the device found; just add it.
5. Tap the device icon to enter the control panel.

Troubleshooting

a) APP cannot find the device.

• Make sure the phone's Bluetooth is on.
• Allow the permissions of the APP; the APP needs them to connect the device.
• Check that the string light is on.
• Close the APP, turn off Bluetooth, and turn on Bluetooth again, then start the APP to add the device again.
• Ensure the phone is within 4ft (1.2m) of the product without obstructions when connecting.
• Your phone may be incompatible with the APP; try another phone.

b) All lights don't work.

• Check that the power is on.
• Connect the APP and turn on the light, then turn up the brightness.

c) Some light beads keep off or fail working.

• Check the pixel number setting on the APP.
• Contact us.

Customer Service

Warranty: 12-Month Limited Warranty

Support: Lifetime Technical Support

Email: service@daybetter.com

Please contact DayBetter if you have any problem or receive a defective product. We will reply within 24 hours.

FCC Statement

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.

Caution: Any changes or modifications to this device not explicitly approved by the manufacturer could void your authority to operate this equipment.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

RF Exposure Information

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment can be used as portable exposure without any restriction.