Miele G 7410 SCi AutoDos Dishwasher Installation Guide
General Information and Safety Precautions
Please observe this installation sheet and read the operating instruction manual supplied with the dishwasher before installation, setup, and commissioning. This will help protect you and prevent damage to your appliance.
- ⚠️ Risk of damage or fire hazard.
- ? Warning: Danger of being cut.
- Do not use a cordless screwdriver; risk of damage.
Observe connection data.
The minimum/maximum weight of the front panel is quoted in the technical data for your dishwasher on the Miele website.
Before moving the dishwasher, screw the feet inwards to secure them.
After fitting the front panel, ensure the door springs are adjusted equally on both sides.
Included mounting accessories and required tools may vary depending on the specific model.
Water Drain Venting
If the on-site drainage connection is situated lower than the guide path for the lower basket rollers in the open door, the drainage system must be vented.
Installation Procedure
Follow these steps for the correct installation of your Miele semi-integrated dishwasher.
Cabinet Preparation and Dimensions
Ensure the cabinet opening meets the required dimensions. Typical width: 590-597 mm. Typical height: 865-930 mm. Ensure sufficient depth (min. 130 mm for hose connections) and clearance.
Mounting the Appliance
Position the dishwasher in the cabinet opening. Attach mounting brackets to the cabinet using appropriate screws (e.g., 4x27mm, 4x20mm). Secure the appliance using the provided fixings.
Water Inlet Connection
Connect the water inlet hose to the water supply. Ensure it is securely fastened.
Drain Hose Connection
Connect the drain hose to the wastewater outlet. Ensure it is properly secured and routed to prevent siphoning or backflow.
Electrical Connection
Connect the power cable to a suitable electrical outlet. Observe the specified connection data.
Securing the Appliance
Use the provided screws to secure the appliance to the cabinet, ensuring it is stable.
Leveling the Dishwasher
Use the adjustable feet to level the dishwasher. Ensure the appliance is stable and does not rock. Check clearances: X = 760-770 mm, Y = 805-815 mm.
Attaching the Front Panel
Mount the decorative front panel onto the appliance door.
Adjusting Door Springs
Adjust the door springs equally on both sides to ensure the door remains open at various angles and closes smoothly.
Water Drain Venting Check
If the drain connection is lower than the basket roller guides, ensure the water drain is vented.
Internal Component Installation
Install internal components such as baskets and spray arms.
Final Checks
Perform a final check of all installations, connections, and clearances. Refer to the operating manual for initial startup and usage instructions.
Included Accessories and Required Tools
The following lists detail common accessories supplied with the dishwasher and tools typically required for installation. These may vary by model.
Included Mounting Accessories (Model Dependent)
| Item | Description/Quantity |
|---|---|
| Screws | 4x27mm, 4x20mm, 4x15mm |
| Brackets | Mounting brackets |
| Clips | Securing clips |
| Hoses | Water inlet and drain hoses |
| Tool | T20 screwdriver |
Required Tools (Model Dependent)
| Tool | Purpose |
|---|---|
| Screwdriver (Phillips/Pozidriv) | For various screws |
| Adjustable Wrench | For hose connections |
| Spirit Level | For leveling the appliance |
| Measuring Tape | For checking dimensions |
| Drill | For pilot holes if necessary |
