QuickShifter easy

Secure the bike on a stand.

[Image: A Husqvarna FS450 motorcycle is shown mounted on a workshop stand.]

Locate the fuel injector connector under the fuel tank.

[Image: A hand is shown connecting a wire harness to the fuel injector connector located beneath the fuel tank of the motorcycle.]

Connect the QSH connectors in-line with the injector connectors.

[Image: Close-up view of the fuel injector connector with the QSH wiring harness being plugged in.]

Connect the QSH black wire terminal to the battery negative terminal.

[Image: The black wire terminal of the QSH unit is shown connected to the negative terminal of the motorcycle's battery.]

Use the original bolt of the gearbox shaft, add the sensor and the original washer exactly as shown in this photo.

[Image: The QSE sensor is mounted onto the gearbox shaft using the original bolt and washer, as depicted in the photograph.]

Mount the QSE sensor.

(Tighten the bolt in this position by about 6 Nm. If you do not have a torque wrench, tighten the bolt until the shift arm is tight on the gearbox shaft.)

[Image: A detailed view of the QSE sensor mounted on the gearbox shaft, showing the correct positioning and the bolt securing it.]

Typical position for the QuickShifter easy.

Secure the unit Properly.

[Image: The QuickShifter easy unit is shown installed in its typical location, likely under the seat or tail section of the motorcycle, secured in place.]