Gymax 47.5 inch Gaming Desk User Manual and Assembly Guide
This document provides the user manual and assembly instructions for the Gymax 47.5 inch Z-Shaped Gaming Desk. It details the components, hardware, and step-by-step assembly procedures to ensure proper setup.
Parts and Hardware List
The following components and hardware are included for assembly:
| Identifier | Description | Quantity |
|---|---|---|
| A | Washer (M8x14x1.5mm) | x8 |
| B | Screw (M8x16mm) | x8 |
| C | Allen Wrench | x1 |
| D | Washer (M6x14x1.5mm) | x4 |
| E | Screw (M6x16mm) | x4 |
| F | Screw (M8x38mm) | x4 |
| G | Washer (M6x25x1.5mm) | x4 |
| H | Screw (M6x20mm) | x2 |
| I | CPU Stand | x1 |
| (Part 1) | Desk Frame Parts | x1 |
| (Part 2) | Crossbar | x1 |
| (Part 3) | Support Bar | x2 |
| (Part 4) | Desk Top | x1 |
| (Part 5) | Cup Holder | x1 |
| (Part 6) | CPU Stand (separate item in steps) | x1 |
| (Part 7) | Headphone Hook | x1 |
Assembly Instructions
Step 1: Assemble the Base Frame
Description: Connect the two main desk frame parts (labeled '1' in diagrams) to form the base structure. Use eight M8x14x1.5mm washers (A) and eight M8x16mm screws (B). Tighten all screws securely using the provided Allen wrench (C).
Step 2: Attach Support Bars
Description: Attach the crossbar (labeled '2') and the two support bars (labeled '3') to the assembled base frame. Secure these bars using four M6x14x1.5mm washers (D), four M6x16mm screws (E), and four M8x38mm screws (F). Ensure all connections are tightened with the Allen wrench (C).
Step 3: Install CPU Stand and Cup Holder
Description: Mount the CPU stand (labeled '6' in diagrams, also referred to as part 'I') and the cup holder (labeled '5') onto the desk frame. For the CPU stand, use four M6x25x1.5mm washers (G) and two M6x20mm screws (H). The cup holder likely uses similar attachment points and hardware.
Step 4: Attach Desk Top and Headphone Hook
Description: Carefully place the desk top (labeled '4') onto the assembled frame. Secure the desk top using the appropriate fasteners (not explicitly detailed in the diagrams but implied). Finally, attach the headphone hook (labeled '7') to the designated point on the desk frame.
