Features
- 1. On/Off switch
- 2. «Release» button
- 3. 19 mm & 32 mm curling tongs
- 4. 19 mm brush & spiral sleeve attachments
- 5. Straightener/waver attachment
- 6. Straightening/crimping plates
- 7. 3D waver plates
- 8. 3 clips to make styling easier and to help you section your hair.
- 9. 12 hairpins to create the styles of your dreams
Use
Before connecting or removing an attachment, make sure the unit is turned off and that the pieces have cooled down.
To connect an attachment, slip it on the metal rod of the handle, press the «release» button on the side of the handle, and push the attachment on firmly until you hear a «click». To remove an attachment, hold the handle and, while pressing the «release» button, slowly pull off the attachment.
To swap the plates of the straightener/waver attachment, hold them by the cool tip and slide them appropriately into the housing of the attachment, until you hear a «click». Make sure the superior and inferior plates match. To extract the plates, hold them by the cool tip, press the two small buttons on the sides of the cool tip, then pull the plates out of the straightener/waver attachment.
Plug the unit in and push the switch to “I”. The power indicator light will light up. Allow it to heat up for a few minutes. Do not touch the heating barrel during use.
Curling tongs
- Comb your dry hair and divide it into equal sections before curling. Press the clamp lever and place the tip of the section between the clamp and the barrel.
- Roll the hair around the tong from the tips to the point where you want the curls to begin. Don’t let the tong touch your scalp. Hold the tong in place for 10 to 15 seconds.
- To remove the curling tong, press the clamp lever to open. To “set” the curl, wait until your hair has cooled before handling.
Brush sleeve attachment
For gentler curls or a gentler style, use the brush sleeve with the 19 mm curling tong. Make sure the barrel is cool. Slide the brush sleeve over the barrel.
- Take up a section of hair and roll around the brush, hold for about 15 seconds and gently unroll. Allow your hair to cool before combing or brushing.
Spiral sleeve attachment
For tight and well-shaped curls, use the spiral sleeve with the 19 mm curling tong.
- Make sure the barrel is cool. Slide the spiral sleeve over the tong.
- Take up a section of hair of about 2-3cm and roll it carefully around the spiral, hold for about 15 seconds and unroll it gently.
- Allow your hair to cool before styling.
Straightener/waver
Use of straightening plates
- Use the straightener on dry hair taking up small sections at a time. Holding the hair taut and beginning at the roots, slide the straightener the length of the hair. Work smoothly so as to avoid creating a ridge in the middle of the section.
- To soften and tame curly hair, use the straightener on the lengths of the hair only, leaving the hair curly at the roots to keep body and volume. For this kind of hairstyle, use the straightener following the shape of the style.
Use of the crimping plates or of the 3D waver plates
- Work with dry hair. Take up a section of hair, place it between the plates and then close the plates. Hold the unit closed for about 15 seconds. Release, and then take up the next part of the section using the last wave as a guide. Always work from the roots to the tips.
Note! When you are using the appliance, you might see some steam. Do not be concerned, this could be because of evaporation of the sebum, some residual hair products (leave in hair care, hairspray, etc.) or excess water that is evaporating from your hair.
Maintenance
Once unplugged and cooled, the appliance may be wiped with a damp cloth. Make sure that it is completely dry before plugging it in again.
