Uline Pure Flow 1000® Eyewash Station

General Information

The H-1297 shipping carton should contain:

• Eye Wash Station
• Emergency Sign
• Hanging Bracket

Before installing S-11507 Pure Flow 1000® Saline Cartridges, inspect the product for damage.

NOTE: S-11507 Pure Flow 1000® Saline Cartridges are sold separately.

Cartridge Installation

NOTE: This eyewash station requires two saline cartridges to be installed at the same time.

1. Close the drain spigot by turning the handle to the rear. (See Figure 1)
2. Remove the cover by lifting it up. (See Figure 2A) Open the activating door. (See Figure 2B)
3. Raise the reservoir to the "Up" position, latch onto the housing by pressing back on the latching tabs. (See Figure 3)
4. Place two S-11507 Pure Flow 1000® Saline Cartridges on the shelf. Nozzle assembly must be in front. (See Figure 4)
5. Pull green latch tabs forward to drop down the reservoir, ensuring that plates are seated on bags and are not resting on the cartridge boxes. (See Figure 5)
6. Replace the cover. (See Figure 6)
7. Remove rubber bands from the activating strap and nozzle. Extend activating straps to the side. Do not pull on the straps. (See Figure 7)
8. Snap the right-hand nozzle into place on the white nozzle plate. An audible 'click' will be heard to confirm that the nozzle is engaged. (See Figure 8)
9. Snap the left-hand nozzle into place on the white nozzle plate. An audible 'click' will be heard to confirm that the nozzle is engaged. (See Figure 9)
10. Position the two black straps over the top of the activation door with the expiration date and batch number visible. Do not twist or cross straps. Close the activation door. (See Figure 10)
11. Position the activating straps over the door and down the raised area on either side of the door handle so the straps cover the labels on the activation door. (See Figure 11)
12. Push the plastic fastener into the hole in the door until the flange is seated against the door. (See Figure 11)
13. Push the center pin of the fastener until it snaps into place flush with the fastener head. (See Figure 11)
14. Position the tamper seal on the middle right-hand side of the door. Half the seal must be on the door and the other half on the unit surface. (See Figure 12)
15. Attach the lock or inspection tag through the tab on the cover. (See Figure 12)