Innokin GO S User Manual

Be part of our community

For the latest news, products and helpful information. You're invited to follow our social media channels.

• facebook.com/Innokin.Technology
• instagram.com/innokintechnology
• twitter.com/innokintech
• reddit.com/r/innokin
• support@innokin.com

CE ☗ ♻️

Components

Top Fill: 2ml Capacity.

Z-coil

Air Flow Control

510 Connection

Battery LED: Power Level

Battery (1500mAh)

Micro-USB Charge port

How To Use

1. Fill the tank and adjust the air flow.
   • Push mouth-piece in the direction of the arrow to slide open top cap.
   • Fill with eliquid.
   • Do not overfill.

   IMPORTANT: WAIT 5 MINUTES FOR THE NEW COIL TO PRIME AFTER FILLING.

   ADJUST THE AIR FLOW: Turn the base to adjust air flow to your ideal draw and enjoy!

2. Power on/off: Click button 5x.

How to Change Coil

IMPORTANT: MAKE SURE THE TANK IS EMPTY BEFORE CHANGING THE COIL.

1. Twist base to open.
2. Pull to remove coil.
3. Insert new coil.
4. Twist base to close securely.

Battery level

• Use a high quality 5V Wall Charger and included micro USB Cable.
• Gently insert micro-USB correctly.
• Do not charge the GOS unattended.
• When GOS is fully charged the LED will show green.

Red: Battery below 20%.

Red & Green: Battery 20% - 70%.

Green: Battery 70% - 100%.

Protections

1. Red LED flashes 4 times: Low voltage protection. Solution: Charge battery.
2. Red&Green LED flashes 4 times: Short circuit protection. Solution: Check the tank/coil and replace the coil.
3. Red&Green LED flashes 3 times: TIME OUT Protection. Solution: Press again.
4. HIGH TEMP protection: When the PCB Temperature exceeds 115°C. Output reduce power until the PCB returns to a safe operating.

Specifications

Important

• Keep 510 Connection clean of debris/eliquid.
• Keep tank at least 1/3 full for best longevity and flavors.
• Do not vape if tank is empty.
• If there is a burnt taste, replace coil.
• Replace coil when there is a reduction in flavour or vapour.