Cecotec Chillin' Ice 1200 Ice Maker

Instruction Manual

Safety Instructions

Temperature Range

Climate RangeOptimum Room Temperature
SNfrom 10 °C to 32 °C
Nfrom 16 °C to 32 °C
STfrom 16 °C to 38 °C
Tfrom 16 °C to 43 °C

Note: Bearing in mind the limiting values of the room temperature range for the climates for which the cooling appliance is designed and that internal temperatures may be affected by factors such as the location of the cooling appliance, room temperature and frequency of door opening, it may be necessary to modify the setting of any temperature-control device according to these factors. If the appliance is operated in an environment other than the specified climate type (i.e., beyond the rated ambient temperature range), it may not be able to maintain the desired compartment temperatures.

Parts and Components

Refer to Figure 1:

Control Panel (Refer to Figure 2):

Note: The graphics in this manual are schematic representations and may not exactly match the product.

Before Use

Operation

Control Panel

Indicator Lights

Using the Product

  1. Clean the ice basket and water tank with lukewarm water and a soft cloth.
  2. Keep the appliance out of direct sunlight and away from heat sources. Place the appliance on a smooth, horizontal surface and make sure to keep it at least 15 cm away from walls and other appliances.
  3. Connect the appliance to an appropriate plug socket.
  4. Open the lid and fill up the water tank with drinkable water without exceeding the MAX mark on the tank. Then insert the ice basket as shown in Figure 3 and close the lid.
  5. Press the Ice-cube Size button to select the size of the ice cubes. Note: If ambient temperature is below 15°C, it's recommended to choose small cubes to prevent them from sticking to one another.
  6. Press the Power button on the control panel to start making ice (the minimum amount of water required is 1L).

The duration of each ice production cycle depends on the ice-cube size selected and the ambient temperature. Small ice cubes take approximately 7 min ± 30s, while large ones take approximately 8 min ± 30s depending on the temperature of the appliance. It's normal for the ice cubes to be smaller and for the production time to be longer during first cycles: this will happen until the appliance reaches an optimal working temperature.

Ice-cube size varies depending on water and ambient temperature.

If the pump runs out of water, the appliance will stop automatically, and the Empty Water Tank indicator light will come on to indicate that the water tank needs to be refilled. Fill up the water tank and press the Power button again to resume ice production.

If the ice basket is full, ice production will stop automatically. The Full Ice Basket indicator light comes on after two cycles in which the appliance detects a full water tank.

It is advisable to change the water every 24 hours to keep it clean. If you don't intend to use the ice maker for a long period of time, empty the tank first.

Cleaning and Maintenance

Self-cleaning function

Hold down the power button for 5 seconds to activate the self-cleaning function. Self-cleaning time is 30 minutes. The large and small ice cube indicator lights will flash alternately during the cleaning process. After cleaning, drain the water by opening the drain plug.

Troubleshooting

ProblemPossible CausePossible Solution
The Empty Water Tank indicator light comes on.The water tank is empty.Fill up the water tank.
The water tank is blocked.Clean the water tank.
Ice cubes stick to one another.The appliance takes too long to make ice.Stop ice production. Once the ice cubes have melted, restart ice production and select small ice cubes.
The temperature of the water in the tank is too low.Change the water in the tank; the water temperature should be between 8°C and 32°C.
The appliance doesn't make ice.Leakage in the cooling system.Contact the official Cecotec Technical Support Service.
Blocked cooling system.Contact the official Cecotec Technical Support Service.

If none of the above solutions solve your problem, please contact the place of purchase or contact the official Cecotec Technical Support Service.

Technical Specifications

Technical specifications may change without prior notice to improve product quality. Made in China | Designed in Spain.

Disposal of Old Electrical and Electronic Appliances

This symbol ♻️ indicates that, according to the applicable regulations, the appliance and/or batteries must be disposed of separately from household waste. When this product reaches the end of its shelf life, you should dispose of the batteries/accumulators and take them to a collection point designated by the local authorities.

Consumers must contact their local authorities or retailer for information concerning the correct disposal of old appliances and/or their batteries. Compliance with the above guidelines will help protecting the environment.

Technical Support and Warranty

Cecotec is liable to the end user or consumer for any lack of conformity that exists at the time of delivery of the product under the terms, conditions, and deadlines established by the applicable regulations. It is recommended that repairs be carried out by qualified personnel.

If at any moment you detect any problem with your product or have any doubt, do not hesitate to contact the official Cecotec Technical Support Service at +34 963 210 728.

Copyright

The intellectual property rights over the texts in this manual belong to CECOTEC INNOVACIONES, S.L. All rights reserved. The contents of this publication may not, in whole or in part, be reproduced, stored in a retrieval system, transmitted, or distributed by any means (electronic, mechanical, photocopying, recording or similar) without the prior authorization of CECOTEC INNOVACIONES, S.L.

Models: Chillin 1200 Ice Maker, Ice Maker, Maker

File Info : application/pdf, 18 Pages, 2.78MB

PDF preview unavailable. Download the PDF instead.

y09x8k1isvfgf9hfuqv7ray3p3qkonz1

References

Adobe InDesign 18.5 (Macintosh) Adobe PDF Library 17.0

Related Documents

Preview Cecotec Power Black Titanium 1800 Smart Blender: User Manual and Safety Instructions
Comprehensive user manual for the Cecotec Power Black Titanium 1800 Smart blender, covering safety instructions, operation, cleaning, maintenance, technical specifications, and warranty information.
Preview Cecotec Bolero DressCode 10950 Autodose Inverter: Manual de Instrucciones
Manual de usuario para la lavadora Cecotec Bolero DressCode 10950 Autodose Inverter. Encuentre instrucciones de instalación, guías de uso, consejos de seguridad y solución de problemas para su electrodoméstico.
Preview Cecotec Twist&Ice 2600: Manual de Instrucciones y Uso
Descubra el manual de instrucciones completo para la máquina de granizados Cecotec Twist&Ice 2600. Aprenda sobre su funcionamiento, limpieza, mantenimiento y solución de problemas para disfrutar de deliciosos granizados en casa.
Preview Cecotec Cremmaet Compactccino Super-automatic Coffee Machine User Manual
Comprehensive user manual for the Cecotec Cremmaet Compactccino Super-automatic Coffee Machine, covering safety instructions, operation, cleaning, maintenance, troubleshooting, and technical specifications.
Preview Cecotec Power Espresso 20 Matic: User Manual & Instructions
Comprehensive user manual for the Cecotec Power Espresso 20 Matic espresso machine, covering safety instructions, operation, cleaning, troubleshooting, and technical specifications.
Preview Cecotec Cumbia Power Espresso 20: User Manual and Operating Guide
Comprehensive user manual for the Cecotec Cumbia Power Espresso 20 espresso machine, covering safety, operation, cleaning, maintenance, troubleshooting, and technical specifications.
Preview Cecotec FreeStyle Latte Capsule Coffee Machine User Manual
Comprehensive user manual for the Cecotec FreeStyle Latte capsule coffee machine, covering setup, operation, cleaning, maintenance, troubleshooting, and technical specifications.
Preview Cecotec FreeStyle Compact Black Coffee Machine User Manual
Comprehensive user manual for the Cecotec FreeStyle Compact Black coffee machine, covering safety instructions, parts and components, operation, cleaning and maintenance, troubleshooting, technical specifications, and warranty information.