vidaXL Bed Frame Assembly and User Manual

Assembly Instructions

Refer to Image 1 for assembly steps.

Parts List:

• Ax1
• Bx1
• Cx2
• Dx2
• Ex2
• Fx2
• Gx1
• Hx1
• Ix4
• Jx2
• Kx24
• Lx12
• Mx6
• Nx4
• Ox12
• Px17
• Qx17
• Rx1
• Sx24
• Tx1
• Ux1
• Vx2
• Wx2
• Xx2
• Yx3

Hardware:

• M6x14 (0.6)
• M6x20 (0.8)
• M6x40 (1.6)
• M8x35 (1.4)

Diagram 1: Shows the components and hardware required for assembly. It illustrates how to connect various parts using screws and other fasteners.

Diagram 2: Illustrates the connection of the LED strip to the controller and the remote control. It also shows a close-up of the LED strip connection and the remote control unit. A note indicates 'A: Not Included', suggesting a component is not supplied with the product.

Diagram 3: Shows the overall assembly of the bed frame, highlighting specific connection points and the placement of components.

Diagram 4: Details the attachment of a support beam to the bed frame, showing the use of screws and washers.

Diagram 5: Depicts the final assembled bed frame with LED lighting.

Diagram 6: Shows the power adapter and remote control for the LED lighting.

Warnings and Personal Safety

• Do not connect this product to any power supply or adapter other than one described in the manual, on the name plate, or specifically recommended by vidaXL.
• This appliance should not be used by children of 14 years or younger, and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge concerning use of electronic appliances.
• Electricity is dangerous. Damage and improper installation, use or alteration (replacement of individual components) can lead to damage to the unit and mains wiring, resulting in electric shock and danger to the user.
• Do not operate this product in explosive atmospheres, such as in the presence of flammable liquids, gases and dust, or above 50 degrees Celsius.
• Do not switch on the product if the connecting cable or adapter are visible damaged.
• Never open or insert anything into electrical fittings or equipment. Doing this sort of thing can lead to serious danger to life from electric shock.
• If the external flexible cable or cord of this luminaire is damaged, it shall be exclusively replaced by the manufacturer or his service agent or a similar qualified person in order to avoid a hazard.
• Turn off power while installing and maintaining. Make sure the bulbs have cooled down.
• The light source of this luminaire is not replaceable; when the light source reaches its end of life the whole luminaire shall be replaced.
• For indoor use only, do not use this product outdoors.
• Warnings: Do not ingest battery, Chemical Burn Hazard. This product contains a coin / button cell battery. If the coin / button cell battery is swallowed, it can cause severe internal burns in just 2 hours and can lead to death. Keep new and used batteries away from children. If the battery compartment does not close securely, stop using the product and keep it away from children. If you think batteries might have been swallowed or placed inside any part of the body, seek immediate medical attention.

Operation Guide

Connect the wires of the controller and LED fittings as per the instruction.

Attention: If the LED strip does not light up after plugging the strip pin into the connector of the remote controller, please plug them again with reverse direction.

Maintenance and Cleaning

To clean the product, always use a dry and soft cloth. Do not use paint, organic solvent, or chemically impregnated cloth. Always disconnect the product from the mains supply or turn off the mains supply when not in use and when cleaning.

Technical Specifications

Company Information

• vidaXL | Haba Trading B.V. | Mary Kingsleystraat 1| 5928SK Venlo | The Netherlands
• vidaXL | HB Commerce PTY LTD | Level 16, 201 Elizabeth Street | Sydney NSW 2000 | Australia
• vidaXL | vidaXL LLC | 2000 W. Baseline Road | Rialto CA 92376 | United States
• www.vidaXL.com