SodaStream Fountain Jet A200 CO2 Tube Replacement
Guide ID: 31415 - Draft: 2015-01-11
In this guide, the seal which carries CO2 will be tightened. This will be done by tightening caps located on the tube.
Written By: Katie Fetters
Introduction
This guide will instruct a person on how to replace the carbonation tube line used in the delivery of CO2.
Step 1 -- Removing the front cover
Locate the two prongs at the bottom of the button which releases the bottles (at the front of the machine).
Push both prongs down together; pull this part of the machine out towards you.
Step 2 -- Removing the back cover
Press in the two gray oval shaped buttons found on either side.
Gently pull back on the cover until it releases from the device.
Release the buttons and pull the back completely off.
Step 3 -- Removing the Carbonation button
Place your hand under the carbonation button and pull up and away from you, towards the back of the machine.
Warning: Be careful not to pull too hard on the carbonation button; there is a spring under this button that can become loose.
Step 4 -- Tightening caps on tubes
Under the carbonation button, at the end of the slim black tube will be a white cap. Turn the cap in a counter-clockwise motion to remove.
Locate the second white cap on the front of the machine.
Reattach both white caps by turning them in a clockwise direction, ensuring they are on tight.
Step 5 -- Putting machine back together
Line up the prongs on the front cover with those on the machine and gently push until in place.
Reassembly
To reassemble your device, follow these instructions in reverse order.
