SodaStream Fountain Jet A200 CO2 Tank Replacement

Introduction

In this guide, the reader will learn how to properly remove an empty CO2 tank and replace it with a new full tank.

Parts:

• Full, SodaStream CO2 tank (1)

Step 1 — CO2 Tank Removal

[Image description: A person's hands are shown pressing two gray buttons on the top sides of the back cover of a SodaStream device.]

[Image description: A person's hands are shown pulling the back cover away from the SodaStream device, revealing the CO2 tank inside.]

• Remove the back cover of the device. Press in the two gray buttons found on either side, located at the top of the machine.
• Pull back on the cover until it releases from the device. Pull the back completely off.

Step 2 — Removing the CO2 Tank

[Image description: A hand is shown grasping a silver CO2 tank inside a SodaStream device.]

[Image description: A hand is shown pulling a silver CO2 tank towards itself and lifting it upwards out of a SodaStream device.]

• Grasp your hand firmly around the CO2 tank and twist it in a clockwise motion.
• Once the CO2 tank is free, pull it towards you and lift upwards to remove it from the device.

Step 3 — Installing the Full CO2 Tank

[Image description: A hand is shown inserting a silver CO2 tank into the base of a SodaStream device.]

[Image description: A hand is shown aligning the CO2 tank valve at the top.]

• Insert the full CO2 tank up through the hole, located at the bottom of the device.
• Line up the new CO2 tank with the valve at the top and twist the tank in, using a counter clockwise motion.

Step 4 — Reattaching the Cover

[Image description: The black back cover of a SodaStream device is shown being aligned with the bottom of the machine, with a CO2 tank visible inside.]

• Line up the small tab on the back cover with its slot near the bottom of the device.
• Gently push the CO2 tank cover completely back onto the machine.

Reassembly

To reassemble your device, follow these instructions in reverse order.