GE Winterberry® White Branch Tree

CAUTION: EXERCISE CARE WHEN UNPACKING AND ASSEMBLING

Nicolas Holiday Ltd. thanks you for purchasing this pre-lit Christmas tree. Should you have any problems with your tree, visit us at www.geholidaylighting.com for more information. You can call our toll-free number at 1-877-398-7337. Check our website for latest service hours and assembly instruction videos.

WARNING:

Risk of fire and electric shock. Disconnect light set from power before starting.

• Keep wires clear of being pinched or cut during assembly or installation.
• Do not press or grasp bulbs during assembly or installation.
• Before starting, make sure stakes are clear of underground sprinkler, telephone, and power lines.
• Please read all instructions and warnings included with this product before using.

1. Carefully unpack, removing any bubble wrap and inspect the contents of your tree.

Fig. A shows the top section, middle section, bottom section, metal stand and 4 stakes, instruction manual and remote control.

Top section

Middle section

Bottom section

Metal stand and 4 stakes

Instruction manual and Remote control

The tree stand should be open and set at a 90° angle. Remember to tighten the thumbscrew after connecting the extender and tree stand. See Fig. B. Untie red twist-tie to release branches. Gently position any branches that do not fall into place. Your assembled tree may be heavy and difficult to move when done, so place the stand in the desired location before assembling. Hang the control box at the bottom section lowest branch (if unattached). Secure in place using the (4) metal stakes.

Fig. B shows the tree stand, thumbscrew, and the process of setting the stand at a 90° angle.

2. When connecting two tree sections, it is important that you align the mark on the tree poles. See Fig. C.

Fig. C illustrates connecting two tree sections, highlighting the alignment marks.

Disconnect the decorative item from the power source before performing any maintenance or cleaning.

For outdoor use only • 120V

THIS IS NOT A TOY, FOR DECORATIVE USE ONLY.

GE is a trademark of General Electric Company and is under license by Nicolas Holiday Ltd.

Nicolas Holiday Ltd.
©2025 Nicolas Holiday Ltd.
Suite 2706 Skyline Tower, 39 Wang Kwong Road,
Kowloon Bay, Kowloon, Hong Kong
All rights reserved. Printed in China NHL Model No. 25055LO

TREE ASSEMBLY DIAGRAM

7 FT

Top section

Middle section

Bottom section

Extender

Control box

Tree Stand

Remote Control

SCHEMATIC DIAGRAM

Assemble section by section.

3. To electrically connect the lighted sections:

First, locate the 2 connector cord tags between each section. Then, fully insert the tree section connectors. Fully screw on the cap to secure connection.

4. To illuminate, find and unhook the long lead wire from the bottom section. Fully insert the direct plug-in adapter into a working GFCI outlet or an outdoor-rated extension cord.

NOTE: Hammer/Mallet may be required for stakes.

Troubleshooting Tips

If one section of your tree does not illuminate, check that section for cut or damage wires or that all electrical connections on the tree are made. Due to unique construction of the light sets, the individual LEDs are not replaceable. The light sets are designed for continued operation even if an individual LED fails to light.

IMPORTANT:

Store your carton neatly in a cool, dry location protected from sunlight to prolong the tree life and to better keep the light sets in working order. Do not place a heavy load on the carton to avoid damage to or crushing the carton and tree inside.

NO Spare Bulbs