RollerMouse Go and RollerMouse Pro
RollerMouse Go
Diagram Description:
- Top side view shows the Rollerbar (H) and buttons C, G, F, D, E.
- Left side view shows the On/Off switch (A).
- Right side view shows the Cursor speed/Settings button (B).
- Top view with cable shows connection ports (4, 5, 6).
Functions
- A. On/Off switch ?
- B. Cursor speed/Settings* ⚙️
- C. Left-click ?️
- D. Right-click ?️
- E. Copy ?
- F. Paste ?
- G. Scroll wheel ?
- H. Rollerbar ?
*The cursor speed button is multifunctional: On its own, it controls cursor speed. Used in a sequence with other buttons, it adjusts device settings. Please read on to learn more about the functionality of this button.
The LED indicators have corresponding tones to indicate a settings status. An ascending tone ? indicates successful activation of a setting. A descending tone ? indicates a setting was not successfully activated.
SliderMouse Pro
Diagram Description:
- Top view shows the Sliderbar (C) and buttons A, B, D, E, F, G, H, I.
- Side view shows buttons A, B, C, D, E, F, G, H, I.
Functions
- A. Cursor speed ⚙️
- B. Power switch ? *
- C. Sliderbar ?
- D. Copy ?
- E. Paste ?
- F. Left-click ?️
- G. Right-click ?️
- H. Scroll wheel ?
- I. "One Touch" double-click ?️?️
* No function for wired unit.
Firmware Update
Updating firmware for RollerMouse Go/SliderMouse Pro/RollerMouse Pro:
- Hold "Cursor speed” button, then turn power on (Press or switch “Power switch”).
- Plug in USB cable on Mouse and PC.
- Open "RollerMouse Go v76" folder (RollerMouse Go as example), then click "program_update”.
- Wait for the update bar process to reach 100%.
Command Prompt Output Example:
The update process shows messages like "Dongle52 in DFU detected. Starting update: please do not unplug until finished. [####################################] 100% Device programmed. Please press any key to continue..".
Note: Step 3 can be ignored with the new Windows Driver 3.1.0 or Mac driver 6.0.6. Automatic update is part of the driver; flash mode needs manual activation for now.
