Amewi Drift Sport Car

Declaration of Conformity

This product has been manufactured according to current technical standards. The product complies with the requirements of the applicable European and national guidelines. The CE conformity has been proven. AMEWI Trade e.K. hereby declares that this product complies with the basic requirements and other relevant provisions of Directive 2014/53/EU (RED).

The full text of the declaration of conformity can be found at: https://amewi.com/de/downloads/index/search/

For further questions regarding the product and conformity, please contact:

AMEWI Trade e.K., Nikolaus-Otto-Str. 18, DE-33178 Borchen, Fax: +49 (0)5251/288965-19, Email: info@amewi.com.

CE Mark: CE

Security and Hazard Warnings

• ⚠️ General Warning: For damages caused by disregarding this manual, warranty expires! Amewi is not liable for consequential damages, material or personal damage caused by improper handling or disregarding safety notices.
• ⚠️ Modification Warning: For safety and registration (CE) reasons, unauthorized modification or alteration of the product is forbidden. Do not disassemble the product.
• ⚠️ Small Parts Warning: Danger of suffocation or risk of injury from small parts.
• The product must not become moist or wet.
• The vehicle should only be used on flat, even, and clean surfaces.
• Even a fall from a small height can damage the product.
• Simultaneous operation of vehicles with the same transmission/reception frequency is not possible as they will interfere with each other.

Battery Notice and Battery Disposal

• ❗ Battery Handling: Batteries/rechargeable batteries do not belong in children's hands. Battery replacement must be performed by an adult.
• Never mix rechargeable batteries with non-rechargeable batteries.
• Never mix fully charged batteries with partially discharged batteries.
• Never mix batteries of different capacities.
• Never attempt to charge dry (non-rechargeable) batteries.
• Ensure correct polarity when inserting batteries.
• Defective batteries/rechargeable batteries should be disposed of properly as special waste.
• Never leave a charging battery unattended.
• For questions about charging time, please read the manual or contact the manufacturer.

Disposal Information

The company AMEWI is registered under WEEE Reg. No. DE93834722 with the EAR foundation and properly recycles all used electronic components. Electrical and electronic devices must not be put into household waste! Dispose of the product at the end of its service life according to applicable legal regulations. As the end-user, you are legally obliged (Battery Ordinance) to return all used batteries and rechargeable batteries; disposal via household waste is prohibited!

Batteries containing hazardous substances are marked with the accompanying symbols, which indicate the prohibition of disposal in household waste. Additional designations for critical heavy metals are: Cd=Cadmium, Hg=Mercury, Pb=Lead (designation is on the battery/rechargeable battery, e.g., below the trash can symbols shown on the left).

Through RoHS labeling, the manufacturer confirms that all limit values were observed during manufacturing.

Batteries marked with the recycling symbol ♻️ can be disposed of in any used battery collection bin (available at most supermarkets at the checkout). They must not be put into residual or household waste.

AMEWI Trade e.K. participates in the dual system for sales packaging via the company Landbell AG. The packaging used is collected from private end-users (households, "Yellow Bag", "Yellow Bin") by partner companies (waste disposal contractors), sorted, and properly recycled. Participation in a dual system contributes to CO2 savings.

Product Operation

Installing Controller Batteries

Loosen the screw and remove the battery cover. Install 2 x 1.5V "AA" batteries, ensuring correct polarity.

Controller Features:

• ON/OFF Switch
• Fine Tuning Dial
• Power Indicator Light

Installing the Car Battery

Loosen the screw and remove the battery compartment cover. Connect the 3.7V Li-ION battery (included) and place it in the battery compartment. Close the battery compartment cover.

Charging the Battery Pack

Connect the USB charging cable to a computer USB port or a power bank, then connect the battery to the charging cable. Charging time is 2-3 hours.

Driving the Car

1. Set the car's switch to the "ON" mode.
2. Turn on the controller (transmitter). The LED on the controller will flash and then turn off in several seconds, indicating that the controller is successfully matched to the car. The LED is continuously lit when the controller is working.

Controls

How to Replace Tires

1. Unscrew the screws holding the drift tires onto the vehicle.
2. Remove the screws and wheels from the vehicle.
3. Install the rubber tires onto the vehicle.
4. Tighten the screws on the wheels.

Note: Replacement of wheels requires adult operation or supervision.