ATUVOS TAG
Disassembly & Replacement of Battery Instruction
- 1
Use your fingernails or insert a smaller tool into the small gap at this position.
(Note: The panel with logo is facing down.)
A white ATUVOS TAG device shown with a blue arrow pointing to a small gap on its edge, indicating where to insert a tool for disassembly.
- 2
Slide left along the gap to the edge.
The ATUVOS TAG device with blue arrows indicating a sliding motion along the gap on its edge.
- 3
Then slide the other side along the gap to the edge.
The ATUVOS TAG device with blue arrows indicating a sliding motion along the opposite gap on its edge.
- 4
Pull up and open the battery cover in the back of the ATUVOS TAG.
The ATUVOS TAG device with its battery cover being lifted upwards, revealing the interior.
- 5
Use a paperclip to remove battery and then replace a new one, placing the battery positive side up ⬆️.
The ATUVOS TAG with the battery cover removed, showing a CR2032 battery. A paperclip is depicted near the battery with an arrow indicating removal. Text labels "Take out" and "Renewed" are visible. A new battery is shown being inserted with its positive side facing upwards.
- 6
Close the battery cover by aligning the top hole on both lids.
The ATUVOS TAG with the battery cover being reattached, showing alignment of the top holes on both the device and the cover.
