Introduction and Safety
This document provides essential instructions for the safe and effective use of the Anko Low Voltage 300 Mixed White Cluster Lights with Remote Control. It is crucial to read these instructions thoroughly before operation and retain them for future reference.
Key Safety Points:
- The light chain is suitable for both indoor and outdoor use, but the AC adaptor MUST be installed indoors, away from weather.
- This product is designed for decorative purposes and not for permanent or long-term use.
- Keep out of reach of children; it is not a toy.
- Ensure cables do not pose a hazard to the elderly, pets, or children.
- Never allow the set to come into contact with heat sources or flames.
- If any part of the light set or cable is damaged, it must be discarded.
- Always switch off or unplug the adaptor when unattended.
Installation Guidelines
Choose an appropriate location, ensuring surfaces are of normal flammability (e.g., wood, plasterboard, masonry) and not highly flammable materials like polystyrene or textiles. Position the lights to avoid being covered by curtains or bedding. Ensure sufficient cable length to reach an indoor mains power socket.
Operation and Remote Control
The product features a wireless remote controller for managing various functions. The remote allows control over ON/OFF, TIMER settings (6 or 18 hours), and selecting from eight different flashing modes (Combination, In Waves, Sequential, Slow Glow, Chasing/Flash, Slow Fade, Twinkle/Flash, Steady On). A DIMMING function offers four levels of brightness (100%, 75%, 50%, 25%). The controller also supports manual button functions for timing and flashing mode selection, and includes a memory function to recall the last used settings.
Adaptor Model: JT-EL/FC24V3.6W-BT3
Adaptor Specifications
The AC adaptor (Model No. JT-EL/FC24V3.6W-BT3) operates on 220-240VAC, 50-60Hz input, with a 0.20A Max current. The output is 24V AC at 3.6W. This is a Class II product intended for indoor use only. Ensure correct voltage and current are used. For installations near normally flammable materials, maintain a minimum clearance of 75mm from the control gear to the building element.
