LOW VOLTAGE 150 LED MULTIFUNCTION WARM WHITE FAIRY LIGHTS
(Model No.: LDL19088FSM K: 43593750 / T: 71361628)
Product Overview
This document provides essential information for the Anko Low Voltage 150 LED Multifunction Warm White Fairy Lights.
The product features a light chain with 150 warm white LEDs. A diagram indicates the layout: the adaptor/plug is on the left, followed by 5 meters of cable, and then the LED lights extend for 11.9 meters.
Important Warnings
- The light chain is suitable for INDOOR AND OUTDOOR USE.
- This product is NOT designed for permanent or long term use.
- The LED driver MUST be installed INDOOR, away from weather.
- The LED driver is suitable for operation of LED Modules only.
- Only operate this light chain with the provided LED driver, Model No. JT-EL/FC24V3.6W-H9.
- Do not connect this light chain electrically to another light chain.
- Do not operate the product while it is still in its packaging.
- DO NOT attempt to replace the non-replaceable bulbs in this light chain.
- Never allow any part of the set to come into contact with a source of heat or flame.
- Care must be taken to avoid damage to the cable or fittings.
- If any part of the light set or cable is damaged, the light set MUST be discarded.
- This product is for use as a decoration only. It is NOT to be used by children as a toy. Keep out of reach of children.
- Do not position this light chain where it will be exposed to extreme wet weather or submerged in water.
- Always switch off this light set or unplug the adaptor if left unattended.
- DO NOT overload power sockets or extension leads.
- DO NOT pierce the cable when securing in place, bend, or stand on the light chain, as this will damage the bulbs or wiring.
- Please refer to the packing or product rating label for product class, specifications, and rating.
Adaptor Manual & Specifications
Please use the equipment according to the rated voltage and current specified.
| Model No. | Input Rated | Output Rated | |||
|---|---|---|---|---|---|
| Voltage | Frequency | Current | Voltage | Power | |
| JT-EL/FC24V3.6W-H9 | 220-240VAC | 50-60Hz | 0.12A Max | 24VAC | 3.6W |
Important Notes:
- Do not open the cover of the equipment.
- For use with LED lighting equipment only.
- The input and output voltage should be checked before use to ensure correct operation.
- This is a Class II product, intended for indoor use only.
- The product is not a toy; keep it where children cannot reach.
- The lamp controlgear does not rely upon the luminaire enclosure for protection against accidental contact with live parts.
- This classification indicates that the controlgear is suitable for operation with LED modules.
- Do-not-cover classification: A symbol indicates that the adaptor should not be covered during use.
The LED driver is designed for safe use near normally flammable materials, including building insulation. However, it cannot be abutted against any material and must not be covered during normal operation.
Minimum Clearance Requirements: A minimum clearance distance of 75mm (A=B=C=Min.75mm) must be maintained from the top and sides of the control gear to any normally flammable building elements. The diagram illustrates this requirement, showing the LED Drivers positioned with adequate space from combustible building structures and insulation, with a required barrier for loose fill or combustible materials.
